Datasheet

4
Absolute Maximum Ratings
Description Symbol Min. Max. Unit
Storage Temperature, Ambient T
S
-65 +100 °C
Operating Temperature, Ambient
[1]
T
A
-55 +85 °C
Supply Voltage
[2]
V
CC
-0.5 +7.0 V
Voltage Applied to Input Logic, dp and Enable Pins V
I
, V
DP
, V
E
-0.5 V
CC
V
Voltage Applied to Blanking Input
[2]
V
B
-0.5 V
CC
V
Soldering Temperature [1.59 mm (0.063 inch) Below Body]
Solder Dipping, max. 5 Seconds 260 °C
Wave Soldering, max. 3 Seconds 250 °C
Recommended Operating Conditions
Description Symbol Min. Nom. Max. Unit
Supply Voltage
[2]
V
CC
4.5 5.0 5.5 V
Operating Temperature, Ambient
[1]
T
A
-55 +85 °C
Enable Pulse Width t
W
100 nsec
Time Data Must Be Held Before Positive Transition of Enable Line t
SETUP
50 nsec
Time Data Must Be Held After Positive Transition of Enable Line t
HOLD
50 nsec
Enable Pulse Rise Time t
TLH
1.0 msec
Optical Characteristics at T
A
= 25°C, V
CC
= 5.0 V
Device Description Symbol Min. Typ. Max. Unit
HDSP-0760 Luminous Intensity per LED (Digit Average)
[3,4]
I
V
65 140 µcd
Series
Peak Wavelength l
PEAK
635 nm
Dominant Wavelength
[5]
l
d
626 nm
HDSP-0770 Luminous Intensity per LED (Digit Average)
[3,4]
I
V
260 620 µcd
Series
Peak Wavelength l
PEAK
635 nm
Dominant Wavelength
[5]
l
d
626 nm
HDSP-0860 Luminous Intensity per LED (Digit Average)
[3,4]
I
V
215 490 µcd
Series
Peak Wavelength l
PEAK
583 nm
Dominant Wavelength
[5,6]
l
d
585 nm
HDSP-0960 Luminous Intensity per LED (Digit Average)
[3,4]
I
V
298 1100 µcd
Series
Peak Wavelength l
PEAK
568 nm
Dominant Wavelength
[5,6]
l
d
574 nm
Notes:
1. The nominal thermal resistance of a display mounted in a socket that is soldered onto a printed circuit board is Rq
JA
= 50°C/W/device. The
device package thermal resistance is Rq
J-PIN
= 15°C/W/device. The thermal resistance device pin-to-ambient through the PC board should not
exceed 35°C/W/device for operation at T
A
= +85°C.
2. Voltage values are with respect to device ground, pin 6.
3. These displays are categorized for luminous intensity with the intensity category designated by a letter code located on the back of the display
package. Case temperature of the device immediately prior to the light measurement is equal to 25°C.