Data Sheet
Table Of Contents
- Overview
- Features
- Applications
- Device Selection Guide
- Package Dimensions
- Absolute Maximum Ratings
- ASCII Character Set
- Recommended Operating Conditions
- Electrical Characteristics
- Optical Characteristics
- AC Timing Characteristics
- AC Timing Frequency Characteristics
- Electrical Description
- Display Internal Block Diagram
- Character RAM
- UDC RAM and UDC Address Register
- Flash RAM
- Control Word Register
- Brightness (Bits 0–2)
- Flash Function (Bit 3)
- Blink Function (Bit 4)
- Current Requirements at Different Brightness Levels (VDD = 5.0V)
- Self-Test Function (Bits 5, 6)
- Clear Function (Bit 7)
- Display Reset
- Mechanical and Electrical Considerations
- Thermal Considerations
- Ground Connections
- Thermal Resistance (θJA) Using Various Amounts of Heatsinking Material
- Soldering and Post Solder Cleaning Instructions for the HDSP-210X/- 211X/250X
- Contrast Enhancement
- Intensity Bin Limits for HDSP-2107
- Intensity Bin Limits for HDSP-211x and HDSP-250x (Except HDSP-2504)
- Intensity Bin Limit for HDSP-2504
- Color Bin Limits
- Packing Information
Broadcom AV02-0629EN
7
HDSP-210x/-211x/-250x Series Data Sheet Eight-Character 5 mm and 7 mm Smart Alphanumeric Displays
AC Timing Frequency Characteristics
Values over temperature range –45°C to +85°C. 4.5V < V
DD
< 5.5V, unless otherwise specified.
Figure 3: Write Cycle Timing Diagram
c. Changing the logic levels of the Address lines when CE = 0 may cause erroneous data to be entered into the Character RAM, regardless of
the logic levels of the WR
and RD lines.
d. The display must not be accessed until after three clock pulses (110 µs min. using the internal refresh clock) after the rising edge of the reset
line.
Symbol Description 25°C (Typ.) Min.
a
a. Worst-case values occur at an IC junction temperature of 150°C.
Unit
F
OSC
Oscillator Frequency 57 28 kHz
F
RF
b
b. F
RF
= F
OSC
/224.
Display Refresh Rate 256 128 Hz
F
FL
c
c. F
FL
= F
OSC
/28,672.
Character Flash Rate 2 1 Hz
t
ST
d
d. t
ST
= 262,144/F
OSC
.
Self Test Cycle Time 4.6 9.2 sec.
1
9
8
6
32
CE
7
10
4 2
5
A
0
-A
4
FL
D
0
-D
7
WR
Input Pulse Levels: 0.6V to 2.4V