User manual

LinkMAX



 HSA300 User Manual

Step 2. Connect the Ethernet cable.

If you are connecting a LAN to HSA300 ADSL/Ethernet router,

attach one end of a provided Ethernet cable to a regular hub port

and the other to the LAN port on HSA300.

If you are using HSA300 with a single computer and no hub, you

must use a “straight” Ethernet cable (provided) to attach the PC

directly to the device. The straight cable is wired differently than the

cable you would use to connect to a hub. When you compare the

colored wires on each end of a straight-through cable, they will be in

the same sequence; on crossover cables, they will not. Contact

your ISP for assistance.

Step 3. Attach the power connector.

Connect the AC power adapter to the Power connector on the back

of the device and plug in the adapter to a wall outlet or power strip.

Step 4: Install USB software and connect the USB cable.

You can attach a single computer to the device using a USB cable.

The USB port is useful if you have a USB-enabled PC that does not

have a network interface card for attaching to your Ethernet

network.

Before attaching the USB cable, you must install a USB driver and

configure the computer. For complete instructions, see page 19.