User manual

LinkMAX



 HSA300 User Manual

Part 2. Configuring IP properties on the USB PC. Now that the

USB driver installation is complete, you must configure the USB PC

so that its IP properties place it on the same subnet as HSA300’s

USB port. There are two ways to do this:

! HSA300 is configured to assign an appropriate IP address

to the USB PC. If you want to use this automatic

assignment feature, called “DHCP server,” you must

configure the USB PC to accept dynamically assigned IP

information.

! If you want to assign a static IP address to the PC, follow

the instructions on page 19 and use the following

information.

•

In the Network and Dial-up Connections window, be

sure to select the icon that corresponds to your new

USB connection (not the one that corresponds to your

Ethernet NIC). When you display the properties for the

icon, the following text should display in the Connect

Using text box:

GlobeSpan USB IAD LAN Modem #n

•

The USB port on HSA300 is preconfigured with these

properties (you cannot change these values):

USB port IP address: 192.168.0.2

USB port subnet mask: 255.255.255.0

Therefore, your PC must be configured as follows:

IP address: 192.168.0.n where n is a

number from 3 to 254.

Subnet mask: 255.255.255.0

Default gateway: 192.168.0.2