Installation Guide

5
7. INSTALL THE HOOD
1. Align the hood and center it above the hood mounting bracket. Gently lower the
hood until it securely engages the bracket.
2. Level the hood.
3. With the hood hanging in place, mark the two hole locations on wall (see
illustration at right).
4. Remove the hood.
5. Drill through marked holes on wall using a 3/32" drill bit.
6. Hang the hood to the wall bracket.
7. Secure the hood to the wall using 2 no. 8 x 1½" Phillips flat head screws for
top holes. Use 2 washers and 2 no. 8 x 1½" Phillips flat head screws for bottom holes.
WARNING
VQ0010
!
!
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
6. REMOVE GREASE FILTERS
Lay the back side of the hood flat on a table. Use a piece of cardboard to
avoid damaging the table or the hood.
To remove the grease filters, pull down on the metal latch tab and tilt each
filter downward. Set filters aside.
hole locatIoNs
HD1292
hole locatIoNs
HD1148