Instructions / Assembly

ManualsBrandsBroan-NuTone ManualsBathHeat-A-Vent 70 CFM Ceiling Bathroom Exhaust Fan with 1300-Watt Heater

MODEL 605RP

Page 1

HEATER / FAN

READ AND SAVE THESE INSTRUCTIONS

To register this product, visit:

www.nutone.com

IMPORTANT INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE INSTALLING

OR USING THIS HEATER.

To reduce the risk of fire, electric shock, or injury to persons, observe

the following:

1. Use this unit only in the manner intended by the manufacturer. If you

have questions, contact the manufacturer at the address or tele-

phone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel

and lock the service disconnecting means to prevent power from

being switched on accidentally. When the service disconnecting

means cannot be locked, securely fasten a prominent warning de-

vice, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

4. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

5. This heater is hot when in use. To avoid burns, do not let bare skin

touch hot surfaces. Keep combustible materials, such as furniture,

pillows, bedding, papers, clothes, etc. and curtains at least 3 feet

(0.9 m) from the front of the heater.

6. Extreme caution is necessary when any heater is used by or near

children or invalids and whenever the heater is left operating and

unattended.

7. Do not operate any heater after it malfunctions. Disconnect power at

service panel and have heater inspected by a reputable electrician

before reusing.

8. Do not use outdoors.

9. To disconnect heater, turn controls to off, and turn off power to heat-

er circuit at main disconnect panel (or operate internal disconnect

switch, if provided).

10. Do not insert or allow foreign objects to enter any ventilation or ex-

haust opening, as this may cause an electric shock or fire, or dam-

age the heater.

11. To prevent a possible fire, do not block air intakes or exhaust in any

manner.

12. A heater has hot and arcing or sparking parts inside. Do not use it

in areas where gasoline, paint, or flammable vapors or liquids are

used or stored.

13. Use this heater only as described in this manual. Any other use not

recommended by the manufacturer may cause fire, electric shock,

or injury to persons.

14. This product must be grounded.

15. Do not install heater in a tub or shower enclosure.

16. This product is designed for ceiling installation only. This product

is designed for installation in ceilings up to a12/12 pitch. Ductwork

must point up. DO NOT MOUNT THIS PRODUCT IN A WALL.

17. Install heater at least 12 inches from floor or any adjacent wall.

18. Do not connect heater to dimmer switch or speed control.

19. Provide a separate 15 AMP circuit. Use 14 GA. power cable of type

which meets code. Use supply wiring rated for at least 90

20. For greatest efficiency, install heater so heat is directed toward tub

or shower area. Avoid directing toward walls or windows.

SAVE THESE INSTRUCTIONS

PREPARATION

1. Remove the

grille bracket.

2. Remove the heater

assembly retaining

screw.

3. Rotate heater assembly

and lift it up and out of the

housing.

4. Remove fan assembly

retaining screws. Lift

fan assembly out of the

housing.

5. Slide the 4 hanger

bars into the slots

on each end of the

housing - 2 hanger

bars per side.

Summary of content (12 pages)

PAGE 1
MODEL 605RP Page 1 HEATER / FAN READ AND SAVE THESE INSTRUCTIONS To register this product, visit: www.nutone.com IMPORTANT INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE INSTALLING OR USING THIS HEATER. To reduce the risk of fire, electric shock, or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2.
PAGE 2
MODEL 605RP Page 2 INSTALLATION WARNING: To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater. CAUTION: High temperature, risk of fire, keep electrical cords, drapery, furnishings, and other combustibles at least 3 feet (0.9 m) from the front of the heater and away from the side and rear. 2. Remove unit temporarily, and pound nails partially into joists at all four marked locations.
PAGE 3
MODEL 605RP Page 3 4. Use a flat-bladed screwdriver to remove the proper electrical knockouts. WIRE OPENING RELEASE SLOT If the switch has not been wired properly and wires need to be moved: Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. 5. Connect electrical wiring as shown. 1. Each wire opening has a release slot. 2.
PAGE 4
MODEL 605RP Page 4 OPERATION Before using heater, make sure heater has been properly installed according to installation steps beginning with the "PREPARATION" section on page 1.
PAGE 5
MODEL 605RP Page 5 MAINTENANCE The following maintenance and cleaning tasks can be performed by the user. All other servicing must be performed by an authorized technician If you have any questions, please consult with our customer service department at: 800-558-1711. LUBRICATION The heater is permanently lubricated and never needs oiling or disassembly. CLEANING Clean heater once a month as follows: 1. Turn off power at service panel. 2. Make sure heating element is cool. 3.
PAGE 6
MODEL 605RP Page 6 SERVICE PARTS KEY NO. PART NO. DESCRIPTION 1 97017451 Housing 2 101183000 Damper / Duct Connector 3 44388000 Mounting Bracket (4 Req.) 4 99270982 Receptacle, Black 99271252 Receptacle, Red 5 82403000 Fan Blower Wheel 6 99080592 Fan Motor 7 97017080 Fan Motor Plate Assembly 8 99260428 Nut (4 Req.) 9 97017824 Grille Assembly (includes Key No.
PAGE 7
MODELO 605RP CALENTADOR / VENTILADOR Para colocar este producto, visite: www.nutone.com Página 7 LEA Y CONSERVE ESTAS INSTRUCCIONES INSTRUCCIONES IMPORTANTES LEA TODAS LAS INSTRUCCIONES ANTES DE INSTALAR O USAR ESTE CALENTADOR. Para reducir el riesgo de incendios, descargas eléctricas o lesiones personales, observe las siguientes precauciones: 1. Use la unidad solo de la manera indicada por el fabricante.
PAGE 8
MODELO 605RP Página 8 INSTALACIÓN ADVERTENCIA: Para reducir el riesgo de incendio, no almacene ni use gasolina u otros vapores y líquidos flamables en las cercanías del calentador. PRECAUCIÓN: Temperatura alta, el riesgo de incendio, mantenga los cables eléctricos, cortinas, muebles y otros materiales combustibles por lo menos 3 pies (0,9 m) del frente del calentador y lejos de la cara y la parte trasera. 2.
PAGE 9
MODELO 605RP Página 9 4. Con un destornillador plano, saque las tapas removibles apropiadas. ENTRADA PARA CABLE RANURA DE DESENGANCHE Si el interruptor no está conectado apropiadamente y hay que cambiar los cables: El trabajo de instalación y el cableado eléctrico deben estar a cargo de personal capacitado, de acuerdo con todos los códigos y normas correspondientes, incluidos los códigos y normas de construcción específicos sobre protección contra incendios. 1.
PAGE 10
MODEL 605RP Page 10 OPERACIÓN Antes de usar el calentador, asegúrese de que esté instalado adecuadamente, de acuerdo con los pasos de instalación indicados en “PREPARACION” en la página 1.
PAGE 11
MODEL 605RP Page 11 MANTENIMIENTO El usuario puede realizar las siguientes tareas de mantenimiento y limpieza. Todos los demás servicios los debe realizar un técnico autorizado. Si tiene preguntas, consulte a nuestro departamento de servicio al cliente llamando al: 800-558- 1711. LUBRICACIÓN El calentador está permanentemente lubricado y nunca necesitará ponerle aceite ni desarmarlo. LIMPIEZA Limpie el calentador una vez al mes tal como sigue: 1. Apague la energía eléctrica en el panel de servicio. 2.
PAGE 12
MODELO 605RP Página 12 PIEZAS DE REPUESTO CLAVE N.º PIEZA N.º DESCRIPCIÓN 1 97017451 Cubierta 2 101183000 Regulador de tiro / conducto 3 44388000 Soporte de montaje (se necesitan 4) 4 99270982 Tomacorriente, negro 99271252 Tomacorriente, rojo 5 82403000 Disco del ventilador 6 99080592 Motor del ventilador 7 97017080 Conjunto de la placa del motor del ventilador 8 99260428 Tuerca (se necesitan 4) 9 97017824 Conjunto de Rejilla (incluyen clave n.