Use and Care Manual

INSTALLATION MANUAL

INSTALLATION

Prepare the Hood

1 ] If present, remove all protective polyfilm from the hood and/or parts.

2 ] Using the finger cup (AVDF1, AVSF1-2 Series) or the tab (AVSF1 Series), remove the grease

filters from the hood by pushing down  and tilting filters out .

3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Remove both

screws holding damper assembly to hood. Remove parts bag (captured behind the damper

assembly). Remove damper assembly from inside the hood and keep the screws for further

use.

4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood

and set it aside.

DAMPER

ASSEMBLY

SCREWS

EZ1

BRACKETS

NOTE: Since this manual covers many range hood models, some details in the following

illustrations may sligthly differ from your unit.