Specification
SPECIFICATION SHEET
REFERENCE QTY. REMARKS Project
Location
Architect
Engineer
Contractor
Submitted by Date
Broan-NuTone LLC, 926 West State Street, Hartford, Wisconsin 53027 (1-800-637-1453)
Broan-NuTone Canada, Inc., 1140 Tristar Drive, Mississauga, Ontario, L5T 1H9 (1-888-882-7626)
Powerful yet quiet blowers - exhaust the cooking area
from a remote location.
FEATURES
BLOWER:
• Low RPM for quiet operation
• Resilient anti-vibration mounts
• Dynamically-balanced, galvanized steel, centrifugal
blower wheel for quiet, efficient performance
• Permanently lubricated, thermally protected motor
• Plug-in motor rated at 120 VAC
• Designed for continuous operation
HOUSING:
• Rugged galvanized steel
• 8-position mounting brackets for easy installation and
greater adaptability to various mounting requirements
• Automatic backdraft damper located within exhaust duct
connector
• Factory-shipped in horizontal discharge position
• May be converted to vertical discharge
• Suitable for kitchen installations
ACCESSORIES INCLUDED:
• 8-inch x 12-inch integrated duct connectors
• Two (2) 8-inch x 12-inch to 10-inch-round transitions
• Hanger kit - for additional installation flexibility
61B 99043709D
* Performance ratings include the addition of a 10” round transition
on inlet and outlet.
SPECIFICATIONS
Model Volts Hz Amps CFM Duct Weight
HLB9 120 60 3.0 700 (V) 8” x 12” * 73.0 lbs.
800 (H)
HLB11 120 60 5.9 1000 (V) 8” x 12” * 73.1 lbs.
1100 (H)
IN-LINE BLOWERS
MODELS HLB9 & HLB11
For use with Broan Elite and NuTone Premier Hoods.
HVI-2100 CERTIFIED RATINGS comply with new testing
technologies and procedures prescribed by the Home
Ventilating Institute, for off-the-shelf products, as they are
available to consumers. Product performance is rated at 0.1
in. static pressure, based on tests conducted in a state-of-
the-art test laboratory. Sones are a measure of humanly-
perceived loudness, based on laboratory measurements.
TYPICAL SPECIFICATION
In-Line Blower shall be Model HLB9, (HLB11).
Unit shall have galvanized steel housing. Housing to have
adjustable mounting brackets.
Blower to include hanger kit, two (2) 8-inch x 12-inch to
10-inch-round transitions, and
8-inch x 12-inch integrated duct connectors.
Automatic backdraft damper to be located within exhaust
duct connectors. Duct connectors, blower assembly and
wiring plate shall be adjustable for either horizontal or vertical
installation.
Blower unit shall be removable from housing and will have
a galvanized steel, centrifugal-type blower wheel. Motor to
be permanently lubricated and mounted with resilient anti-
vibration mounts.
Air delivery shall be no less than listed for each model. All
air ratings shall be certified by HVI. Units to be UL and cUL
listed.
8” x 12”
DUCT CONNECTOR