User's Manual

Page11
2.7 FCC/ISEDC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules and licence-exempt RSS standards. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Toute modification ou modification non expressément approuvée par la partie responsable de la
conformité pourrait annuler l’autorisation de l’utilisateur d’utiliser l’équipement.
Cet appareil est conforme à la section 15 des règles de la FCC et aux normes RSS exemptes de licence.
L’opération est soumise aux deux conditions suivantes: (1) cet appareil ne peut pas causer d’interférences
nuisibles, et (2) cet appareil doit accepter toute interférence reçue, y compris les interférences qui
peuvent causer un fonctionnement indésirable.
ce dispositif est conforme aux règles de la partie 15 de la rss et exempts de licence.
RF Exposure Statement:
This equipment complies with FCC/ISEDC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.
Énoncé d’exposition RF:
Cet équipement est conforme aux limites d’exposition aux rayonnements FCC/ISEDC établies pour un
environnement non contrôlé. Cet équipement doit être installé et exploité avec une distance minimale de
20cm entre le radiateur et votre corps.
FCC/ISEDC Label Instructions:
Physical or e-label stating “Contains FCC ID: 2ADLL-RGB001” or “Contains IC: 2143B-RGB001” with
finished product. Any similar wording that expresses the same meaning may be used.
L'étiquette physique ou électronique indiquant Contient le FCC ID: 2ADLL-RGB001 ou Contient
IC: 2143B-RGB001 avec le produit fini. Toute formulation similaire exprimant le même sens peut être
utilisée.
Regulatory Module Integration Instructions:
This device complies with part 15.247 of the FCC Rules and RSS-247 of RSS standards.
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user’s manual of the end product which integrates this module.
The Bluetooth antenna is integral PCB antenna and maximum gain is 0dBi.
This Bluetooth module has been granted modular approval for bath fan application.OEM integrators for
host products may use the module in their final products without additional FCC certification if they meet
the following conditions. Otherwise, additional FCC/ISEDC approvals must be obtained.