Installation guide

ManualsBrandsBroan ManualsRange hoodOfficial Broan range hood

BHOAN

MODEL 113023

WARNING Z_

INTENDEDFOR DOMESTICCOOKINGONLY.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,

OBSERVETHE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If you have

questions, contact the manufacturer at the address or telephone number listed

in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel and lock the

service disconnecting means to prevent power from being switched on

accidentally. When the service disconnecting means cannot be locked, securely

fasten a prominent warning device, such as a tag, to the service panel.

3. lnstal[ationworkandelectricelwiringmustbedonebyaqualifiedperson(s) in

accordanqe with all applicable codes and standards, including fire-rated

construction codes and standards.

4. Sufficient air is needed for orocer combustion and _xhsustina nf oases thrmsnh

the flue (chimney) of fuel btJrni'ngequipment to prevent backc/'raft_ng. Foiiowthe

heating equipment manufacturer's guideline and safety standards such as

those published by the National Fire Protection Association (NFPA), and the

American Society for Heating, Refrigeration and Air Conditioning Engineers

(ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and

other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Do not use this unit with an additional speed control device.

8. To reduce the risk of fire, use only metal ductwork.

9. Use with approved cord-connection kit only.

10. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE RRE:

1. Neverleavesurfaceunitsunattendedathighsattings. Boiloverscausesmoking

and greasy spillovers that may ignite.

2. Always turn hood ON when cooking at high heat or when cooking flaming foods.

3. Clean ventilating fans frequently, Grease should not be allowed to accumulate

on fan or filler.

4. Use proper pan size. Always use cookware appropriate for the size of the

surface element,

This hood requires installation of a

rough-in plate, ductwork and elec-

trical wiring before installing hood.

Refer to the instruction sheet packed

with the rough-in plate.

WARNING Z_ Z_k

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP

GREASE FIRE, OBSERVE THE FOLLOWING:

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, turn off

the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out

immediately, EVACUATEAND CALLTHE FIRE DEPARTMENT

2. NEVER PICK UP A FLAMING PAN - You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels - a Violent stream

explosion will result,

4. Use an extinguisher ONLY if:

A, You know you a Class ABC extinguisher and you already know how to

operate it.

B. The lire is small and contained in the area where it started.

C. The firedepartment isbeingca!!ed.

D. You can fightthe firewithyour back to an exit.

*Based on "Kitchen Firesalety Tips" published by NFPA.

CAUTION

1. Forgeneralventilating useonly. Donot use to exhaust hazardous or explosive

materials and vapors.

2. To avoid motor bearing damage and noisy/and or unbalanced impellers, keep

drywall spray, construction dust, etc. off power unit.

3. For best capture of cooking impurities, your range hood should be mounted

18-24" above the cocking surface.

4. This product is equipped with a thermostat which may start fan automatically.

To reduce the risk of injury, switch power off at service panel and lock service

panel to prevent power from being switch on accidentally.

5. Your hood motor has thermal overload which will automatically shut off the

motor if it becomes overheated. The motor will restart when it cools down. If

the motor continues to shut and restart, have the hood serviced.

6, Please read specification label on product for further information and

requirements.

IRK

This hood is shipped set up for cabinets

which are 30" high. It can be adjusted in 1"

increments from 30" down to 24" high.

SHIPPED

FACE FRAME & DOORS

(provided by installer)

(ADJUSTABLE)

INSTALLER: Leave this manual with the homeowner.

HOMEOWNER: Use and care information on page 5,

Summary of content (8 pages)

PAGE 1
BHOAN MODEL 113023 INTENDEDFOR DOMESTICCOOKINGONLY. WARNING Z_ WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVETHE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally.
PAGE 2
HARDWARE CONTAINED PARTS BAG IN r I I i t I 4. Remove duct knockout on top or back of hood as appropriate.
PAGE 3
I N STALL DOO R ASSE M B LY i I(.) I(.)@ I(Q)@ FOR UNDER,SOFFIT INSTALLATIONS ONLY: Cut 5/16" off top edge of wood frame for clearance. I (J) -.,/ L 3. Attach hood to rough-in plate with two screws and nuts. Install one lock nut on each vertical adjustment stud at top of hood. 1, Attach wood frame using ten screws. Bottom edge of frame should be 1/8" below bottom edge of metal frame. 2. Mount cabinet doors to wood frame hardware as rest of cabinetry.
PAGE 4
SPEC IAL IN STALLATI'O NS CABINETS LESS THAN 30" HIGH FRAM ELESS CABI N ETS ADJUST HOOD HEIGHT TO MATCH CABINET HEIGHT 1. Construct a panel as shown above. Attach it to door frame with ten screws. 1. AdjuSt hood and door frame height to match cabinet height. 2. Duct length for a 30" high cabinet should be 14-3/4" from rough, in plate. Trim back duct for lesser heights, accordingly. Example: 28" cabinet height requires duct length of 12-3/4". 2. Attach doors.
PAGE 5
USE AND CARE OPERATION For best results, alwaysturn on your hood before you begin cooking. Let hood run for a few minutes after you turn off range to allow hood to clear the air in the kitchen. Pull out hood front to turn on blower and light. Light can also be turned on when hood front Isclosed, The hood front must be out and the speed control turned on for the blower to start. SPEED CONTROL speeds and sound I_vels.
PAGE 6
SERVICE ........ -""I-" Model i .... PARTS -----TYT_---- 113023 KEY NO. ,,,,,,, PART NUMBER 1 2 97007476 99160332 Hideaway 7 8 10 DIAGRAM : ..... 60 HERTZ t2O VOLTS J L [ I ROUGH-IN I WIRING KIT II BOX w---} m WHT _ WHT R _ :BLOWER I I tl ,I oro THERMOSTAT i m _, = STARTER m OR BRN -].G.T I 1SWITCH I KEY NO.
PAGE 7
11 8 12 38 43 \ 44 34 @ 37 @ 30 l 31 28 32 / \ \ ! 36 29 35 32 31
PAGE 8
SERVICE PARTS Model 113123 Hideaway Hood Rough-in Kit KEY NO. 1 PART NUMBER DESCRIPTION 97007472 Rough-InPlate I U'O_'_ X /2 _lUt:_ll _IUUIIU OUlrc_W (2 Required) 3 4 5 6 7 8 98003370 99150415 99440073 99400052 99220287 99250917 Wiring Box Cover #8B Sheet Metal Screw Power Cord Strain Relief Bushing 5/16-10 x 3 Lag Screw* 5/16- Flat Washer* (2 Required) (2 Required) *Standard Hardware. May be purchasedlocally.