Installation Guide

INSTALL THE HEATER ASSEMBLY OPTIONAL WIRING CONVERSIONS
WIRING DIAGRAM
1. Remove housing mask.
Make sure wall has been finished (including paint or wall
paper, etc.) Take out and discard the cardboard mask from
inside of housing.
240 VAC to 120 VAC Conversion.
This heater can be converted to operate on 120 VAC.
1)Disconnect black wire from white wire.
2
TABS
FASTEN TO
HOUSING WITH
RETAINING SCREW -
HERE
MODEL 165F
MODEL 165F
2)Connect the two (2) white wires with insulated terminals to
each other.
3)Connect black wire to terminal on motor.
Place element end of heater assembly behind the tabs on
the left side of housing. Pivot the assembly in and fasten
with retaining screw from parts bag.
Plug wiring harness into receptacle.
3. Provide desired control.
The heater finish assembly has no adjustable thermostat
control.
If a wall-mounted control has been pre-wired, nothing else
need be done.
If a built-in thermostat is desired, purchase and insert the
Broan Model 83 Integral Thermostat at this time.
2. Install heater assembly into housing.
BLACK WIRE
(from motor)
WHITE WIRES
(2) BLACK
WIRES
(connected
to motor)
(2) WHITE WIRES