Model 629004 BROAN MFG. CO., INC. 1926 W. State St.
READ AND SAVE THESE INSTRUCTIONS WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally.
INSTALL THE DUCTWORK ROOF CAP NOTE: To reduce the risk of fire, use only steel ductwork. 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible. 4. Install a roof or wall cap. Connect 6" round steel ductwork to cap and work back towards hood location.
WIRING Note: This range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes. 1. Remove the wiring box cover. Remove a knockout from the wiring box. 2. Feed 6" of power cable through the knockout opening and secure cable to the wiring box with an appropriate connector. 3. Make electrical connections. Connect white to white, black to black and green to green. 4. Replace wiring box cover and screws.
INSTALL DECORATIVE FLUE SWITCH CABLE 1. Hold the decorative flue near the top of the hood. Connect the switch cable from the hood to the decorative flue, as shown. 2. Slide the lower decorative flue section downward and into the channels on the hood. CHANNEL LOWER DECORATIVE FLUE SECTION CHANNEL 3. Raise upper decorative flue section and attach it to the flue mounting bracket with screws (supplied).
MAINTENANCE Grease Filter Clean the grease filter frequently. Remove the grease filter by pulling it downward. Use a warm detergent solution. Grease filters are dishwasher safe. Note: Avoid damage to bulbs by carefully aligning filter openings with bulbs. GREASE FILTER Interior Hood Cleaning DISCONNECT POWER TO HOOD BEFORE CLEANING! 1. Remove the grease filter as shown above. 2. Remove the light bulbs. (See “HALOGEN BULBS” on next page. 3. Remove the metal grille held in place with four (4) screws. 4.
OPERATION LIGHT BLOWER BLOWER SPEED RESET SWITCH SPEED LOWER HIGHEST Controls The hood is operated using the (7) push-buttons located at eye-level, on the front of the decorative flue. The light switch turns the halogen lights on and off. The blower on-low / off switch turns the blower on to its previous running speed. The blower must be turned on using this switch. Turn the blower off by pressing this switch a second time. The blower speed lower switch lowers the blower’s running speed.
WARRANTY BROAN ONE YEAR LIMITED WARRANTY Broan warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OR MERCHANT ABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
SERVICE PARTS 62000 SERIES RANGE HOOD KEY NO. PART NO.
SERVICE PARTS 62000 SERIES RANGE HOOD - 10 -