Installation Guide

ManualsBrandsBroan ManualsFan9815WH

INSTALLATION INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

Wall Heaters

9810WH, 9815WH SERIES

READ ALL INSTRUCTIONS BEFORE INSTALLING OR

USING THIS HEATER.

To reduce the risk of fire, electric shock, or injury to persons,

observe the following:

1. Use this unit only in the manner intended by the

manufacturer. If you have questions, contact the

manufacturer at the address or telephone number listed

in the warranty.

2. Before servicing or cleaning unit, switch power off at

service panel and lock the service disconnecting means

to prevent power from being switched on accidentally.

When the service disconnecting means cannot be

locked, securely fasten a prominent warning device,

such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by

a qualified person(s) in accordance with all applicable

codes and standards, including fire-rated construction

codes and standards.

4. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

5. This heater is hot when in use. To avoid burns, do not

let bare skin touch hot surfaces. Keep combustible

materials, such as furniture, pillows, bedding, papers,

clothes, etc. and curtains at least 3 feet (0.9 m) from the

front of the heater.

6. Extreme caution is necessary when any heater is used

by or near children or invalids and whenever the heater

is left operating and unattended.

7. Do not operate any heater after it malfunctions.

Disconnect power at service panel and have heater

inspected by a reputable electrician before reusing.

8. Do not use outdoors.

9. To disconnect heater, turn controls to off, and turn off

power to heater circuit at main disconnect panel (or

operate internal disconnect switch, if provided).

10. Do not insert or allow foreign objects to enter any

ventilation or exhaust opening, as this may cause an

electric shock or fire, or damage the heater.

11. To prevent a possible fire, do not block air intakes or

exhaust in any manner.

12. A heater has hot and arcing or sparking parts inside. Do

not use it in areas where gasoline, paint, or flammable

vapors or liquids are used or stored.

13. Use this heater only as described in this manual. Any

other use not recommended by the manufacturer may

cause fire, electric shock, or injury to persons.

14. Install heater at least 6 inches from floor or any adjacent

wall.

15. To avoid electrical shock: Do not install unit in a tub or

shower enclosure or any location where it may come in

contact with water. Never place a switch where it can be

reached from a tub or shower.

16. This product may ONLY be installed vertically in a wall.

Do not mount in any other position.

17. Do not connect heater to dimmer switch or speed control.

18. This product must be grounded.

SAVE THESE INSTRUCTIONS

IMPORTANT INSTRUCTIONS

SAFETY INSTRUCTIONS

• Carefully read all instructions and product labels before

beginning installation.

• Only mount the heater in a vertical position.

• Mount the heater at least 6” above the finished floor.

• Do not mount the heater over a bathtub or in a shower stall

enclosure.

• When mounted, the heater should not be closer than

12” to an adjacent wall.

• Do not block the wall heater — i.e., by mounting under a

towel rack, behind a door, etc.

ELECTRICAL SPECIFICATIONS

NOTE: See wiring label on heater housing. The heater

may be wired for either 120V or 240V operation and

requires a separate circuit.

UNIT DIMENSIONS

Housing: 12

/2” high x 10

/2” wide x 3

/8” deep.

Grille: 14

/4” high x 11

” wide x 1” deep.

Wall Cutout: 12

/8” high x 10

/8” wide.

Summary of content (12 pages)

PAGE 1
INSTALLATION INSTRUCTIONS READ & SAVE THESE INSTRUCTIONS! Wall Heaters 9810WH, 9815WH SERIES IMPORTANT INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE INSTALLING OR USING THIS HEATER. 13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. To reduce the risk of fire, electric shock, or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer.
PAGE 2
INSTALLATION NEW CONSTRUCTION “B” UNIT MOUNTING HOLE - TOP AND BOTTOM WARNING: To reduce the risk of fire, do not store or use gasoline or other flammable vapors and liquids in the vicinity of the heater. CAUTION: High temperature, risk of fire, keep electrical cords, drapery, furnishings, and other combustibles at least 3 feet (0.9 m) from the front of the heater and away from the side and rear. MOUNTING THE HOUSING (New Construction) FIGURE 1 Refer to Figure 1. 1. C hoose heater location.
PAGE 3
WIRING CONNECTIONS 120vAC GREEN OR BARE GROUND GREEN GROUND Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. 1. While making wiring connections, support the heater assembly on the bottom of the rough-in frame. 2. F or 120 Volt operation, make wiring connections as shown in Figure 4. 3. F or 240 Volt operation, make wiring connections as shown in Figure 5. 4.
PAGE 4
OPERATION Turn thermostat fully clockwise to HIGH position. Allow heater to run until room is at desired temperature. Adjust thermostat as required to maintain desired temperature. Turn the thermostat to FULL COUNTERCLOCKWISE position when operation is no longer desired. Thermal protector: If for any reason temperatures increase beyond normal limits, a safety thermal fuse will shut heater off. The heater will require servicing by a qualified electrician.
PAGE 5
MAINTENANCE The following maintenance and cleaning tasks can be performed by the user. All other servicing must be performed by an authorized technician If you have any questions, please consult with our customer service department at: 800-558-1711. LUBRICATION The heater is permanently lubricated and never needs oiling or disassembly. CLEANING Clean heater once a month as follows: 1. Turn off power at service panel. 2. Make sure heating element is cool. 3.
PAGE 6
SERVICE PARTS Key No. 1 2 3 4 5 6 7 8 9 Part No. WARRANTY Description 99111432 99360253 52872039 97018621 97018622 57271000 33384000 33178000 99521763 99271433 Limited Warranty Warranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to the original consumer purchaser of its product (“you”) that the product (the “Product”) will be free from material defects in the Product or its workmanship for a period of one (1) year from the date of original purchase.
PAGE 7
INSTRUCCIONES DE INSTALACIÓN ¡LEA Y CONSERVE ESTAS INSTRUCCIONES! Calefactores de pared SERIES 9810WH, 9815WH INSTRUCCIONES IMPORTANTES LEA TODAS LAS INSTRUCCIONES ANTES DE INSTALAR O USAR ESTE CALENTADOR. 14. Instale el calentador por lo menos 6 pulg. desde el piso o cualquier pared adyacente. Para reducir el riesgo de incendios, descargas eléctricas o lesiones personales, observe las siguientes precauciones: 15. Para evitar golpe eléctrico: No instale la unidad en una bañera o recinto de ducha.
PAGE 8
INSTALACION ADVERTENCIA: Para reducir el riesgo de incendio, no almacene ni use gasolina u otros vapores y líquidos flamables en las cercanías del calentador. CONSTRUCCIÓN NUEVA PRECAUCIÓN: Temperatura alta, el riesgo de incendio, mantenga los cables eléctricos, cortinas, muebles y otros materiales combustibles por lo menos 3 pies (0,9 m) del frente del calentador y lejos de la cara y la parte trasera.
PAGE 9
CONEXIONES DE LOS CABLES 120 V CA CABLE DE TIERRA VERDE O DESNUDO CABLE DE TIERRA VERDE 4 AMARILLO 3 BLANCO 2 1. Al hacer las conexiones eléctricas, apoye el montaje del calefactor en la parte inferior de la armazón empotrada. 2. P ara el funcionamiento con 120 V, haga las conexiones indicadas en la figura 4. 3. P ara el funcionamiento con 240 V, haga las conexiones indicadas en la figura 5. 4. H aga las conexiones con tuercas de alambre. Aísle todas las conexiones con cinta eléctrica.
PAGE 10
FUNCIONAMIENTO Gire el termostato completamente en sentido de las agujas del reloj a la posición alta (HIGH). Déjelo funcionar hasta que la habitación llegue a la temperatura deseada. Ajuste el termostato de ser necesario para mantener la temperatura deseada. Para detener el funcionamiento del termostato, gírelo a la posición TOTALMENTE EN SENTIDO CONTRARIO A LAS AGUJAS DEL RELOJ.
PAGE 11
MAINTENIMIENTO El usuario puede realizar las siguientes tareas de mantenimiento y limpieza. Todos los demás servicios los debe realizar un técnico autorizado. Si tiene preguntas, consulte a nuestro departamento de servicio al cliente llamando al: 800558-1711. LUBRICACIÓN El calentador está permanentemente lubricado y nunca necesitará ponerle aceite ni desarmarlo. LIMPIEZA Limpie el calentador una vez al mes tal como sigue: 1. Apague la energía eléctrica en el panel de servicio. 2.
PAGE 12
PIEZAS DE REPUESTO Clave n.º 1 2 3 4 5 6 7 8 9 Pieza n.º GARANTÍA Descripción 99111432 99360253 52872039 97018621 97018622 57271000 33384000 33178000 99521763 99271433 Garantía limitada Periodo y exclusiones de la garantía: Broan-NuTone LLC (la “Compañía”) garantiza al consumidor comprador original de su producto (“usted”) que el producto (el “Producto”) estará libre de defectos en materiales o en mano de obra, por un periodo de un (1) año a partir de la fecha de compra original.