Installation Manual

INSTALLATION MANUAL

INSTALLATION

6 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap.

7 ] Remove Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal exhaust)

of hood. For knockout removed from back of hood, install an appropriate strain relief, 1/2” diameter

(not included). For knockout removed from top of hood, the strain relief will be installed later.

EZ1

BRACKETS

ELECTRICAL

POWER CABLE

KNOCKOUT

NOTE: The damper assembly has to be slightly bent to fit inside the range hood. Once removed,

bent it back to ensure its opening is rectangular (4 corners at 90°).

5 ] Remove the damper assembly, taped over the EZ-1 brackets, and the parts bag, taped on the

inner back of hood, near the left corner.

DAMPER ASSEMBLY

PARTS BAG LOCATION

RECIRCULATION

COVER PLATE

SCREWS

NON-DUCTED INSTALLATION ONLY

8 ] Remove 3 screws retaining the recirculation cover plate to the hood. Discard this plate

with its screws.

9 ] Peel off and discard the membrane covering the recirculation grille, ensuring the

openings are totally cleared.