ADA Wiring Instructions

MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
MOTOR SWITCH
TERMINALS
LIGHT SWITCH
TERMINALS
BLACK WIRE
RED WIRE
FROM 14/3 CABLE
A
B
NOTE: The light switch in rocker switch controls differs from models to others; some light switch have 2 terminals while others have
3 terminals. The illustrations below applies to both light switch models.
A Cut the BLACK wire that is connected to motor switch and light switch.
B Cap off the BLACk wire connected to the light switch terminal. Connect the RED
wire from 14/3 cable to the BLACK wire from the motor switch, using an appropriate
wire nut.
RED WIRE CONNECTION
LIST OF SINGLE BLOWER RANGE HOODS COMPATIBLE WITH THIS PROCEDURE
Once all the connections are done, finalize the installation by reversing steps  to  on first page.
NOTE: Be careful while reinstalling wiring cover to the hood.
CAUTION
Ensure both tabs on inner top of hood are engaged in their corresponding slots in wiring cover. Also, take care not
to pinch wires while reinstalling wiring cover.
SCREW
TABS ON INNER
TOP OF HOOD
ENGAGED IN
WIRING COVER
SLOTS.
3
Broan Series: BCS3, BCSD, BCSEK, BKSA, BKSF, BNSC, BQSEN, BQSJ, CLSC, CRSA and CRSF
NuTone Series: AHSA, AVSF, NCS3, NCSEK, NKSA and NQSEN
Venmar Bistro Series: VBNSA
Venmar Chef Series: VCQSEN