BCSD Additional Info

ADA HIGH VOLTAGE WIRING INSTRUCTIONS FOR SINGLE BLOWER RANGE HOODS WITH

ROCKER SWITCH CONTROL

WARNING

For residential (domestic) installation only. Before proceeding, switch power off at service panel and lock service

disconnecting means to prevent power from being switched on accidentally. Installation work and electrical wiring

must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated

construction codes and standards. Also, it is recommended to wear safety glasses and gloves.

ACCESS TO RANGE HOOD CONTROL PANEL CONNECTIONS

 Remove filters from the hood and set them aside.

NOTE: Some models have only one filter.

 Remove the wiring cover (shaded part on illustration below)

retaining screw. Slide out the wiring cover from the hood and set

it aside with its screw.

 Unplug the blower connector from the main harness.

NOTE: The illustrations in this procedure are generic; some hood details may slightly differ from the hood you have on hand but the

procedure itself applies to all single blower range hoods listed in this document (see page 3).

Wiring cover

screw

 Using a 11/32'' socket, remove the 6 nuts retaining the blower

chamber to the hood assembly (2 nuts on inner back and 2 other

nuts per sides), then use a Phillips no. 2 screwdriver to remove

both front corner screws. See picture below for nuts and screws

locations. Pull out the blower chamber from the hood assembly

and set it aside with its retaining screws and nuts.

HE0253

HD0672

Nuts

Screw

 Remove and set aside the 4 front screws retaining the bent plate

to the hood.

HD0673

Screw locations

 Fold back the bent plate to access to control panel connections.

HD0674

99045858A

PAGE 1
ADA HIGH VOLTAGE WIRING INSTRUCTIONS FOR SINGLE BLOWER RANGE HOODS WITH ROCKER SWITCH CONTROL ! WARNING For residential (domestic) installation only. Before proceeding, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards.
PAGE 2
CAUTION Use standard switches that are rated 120 VCA, 15 A. Only use wires suitable for at least 90oC (194oF). Ensure the wires are reliably routed away from the halogen lights (if present). According to your needs, there are 2 ways to wire a 2-rocker switch control to these range hoods: 120 VAC power cable entering the range hood or 120 VAC power cable entering the switch box. 120 VAC POWER CABLE ENTERING THE HOOD 2-ROCKER SWITCH Install a 2-rocker switch at a convenient place for the user.
PAGE 3
RED WIRE CONNECTION NOTE: The light switch in rocker switch controls differs from models to others; some light switch have 2 terminals while others have 3 terminals. The illustrations below applies to both light switch models. MOTOR SWITCH TERMINALS LIGHT SWITCH TERMINALS A A Cut the BLACK wire that is connected to motor switch and light switch. BLACK WIRE MOTOR SWITCH TERMINALS LIGHT SWITCH TERMINALS B Cap off the BLACk wire connected to the light switch terminal.