Installation Guide

INSTALLATION MANUAL

INSTALLATION

RECIRCULATION

COVER PLATE

SCREWS

NON-DUCTED INSTALLATION ONLY

7 ] Remove 3 screws retaining the recirculation cover plate to the hood. Discard this plate with

its screws. Peel off and discard the membrane covering the recirculation grille, ensuring

the openings are totally cleared.

5 ] Remove the parts bag, taped on the inner back of hood, near the left corner. Remove the

EZ1 brackets from inside the hood by cutting off the tie wrap. Discard the tie wrap.

6 ] Remove Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal

exhaust) of hood. For knockout removed from back of hood, install an appropriate strain

relief, 1/2” diameter (not included). For knockout removed from top of hood, the strain relief

will be installed later.

EZ1

BRACKETS

ELECTRICAL

POWER CABLE

KNOCKOUT

PARTS BAG LOCATION