Installation Guide

11
www.Broan-Nutone.com | 800.558.1711 DEH 3000/R Installation Instructions
OPERATION
Onthedisplayscreen,asolid“O”infrontofanyofthe3functions(SETPOINT,VENT,FAN)indicatesthe
functionisoperating.Aashing“O”indicatesitisinawaitmodeandnotavailableatthemoment.No“O”
indicates the function is currently OFF.
Solid “O” Before
Indicates
SETPOINT Dehumidieron
VENT Fresh air ventilation cycle in progress
FAN Fan on
Wait mode is a factory-programmed time period meant to prevent short cycles. This extends the life of the
dehumidier.Whenaashing“O”isencountered,theunitisinwaitmodeandITCOULDBEUPTO10
MINUTESBEFOREOPERATIONRESUMES.
Display
• Wheneverthereispowertothecontrol,itwilldisplaythetime,the
day, %RH, and temperature.
• WhenthecontrolisactuallyswitchedON,the%RHsetpoint,fan
status,runmode(programorhold),andfreshairventilationstatus
is displayed.
• Whenakeyispressedthedisplaywilllightforapproximately30
seconds.
• TimeandDayaredisplayedatthetopofthescreen.
• RHandTemperaturearedisplayedinrealtime.
• Asolid“O”beforetheSETPOINT,VENT,ORFANindicatesthe
function is operating.
• Aashing“O”beforetheSETPOINT,VENT,ORFANindicatesthe
unit is in wait mode.
• WhenthesystemisOFF,thecontrolwilldisplaythetime,day,
%RH, and temperature.
• Whentheunitisshipped,itisinmanual(hold)mode.
Set Up
During the set-up process, if you make a mistake, simply continue.
You can always go back to adjust the settings. If you leave the
control alone and don’t touch any buttons for 10 seconds, the
control will remember any changes made and return to the normal
display screen, allowing you to proceed to the next step.
For Installer and Homeowner:
DEH 3000/R ON
DEH 3000/R OFF