Installation Guide

ManualsBrandsBroan ManualsAccessoriesDehumidifier Surface Mount Kit

Step 1. Install Foam Tape to Surface Mount Kit

In-Wall Dehumidiﬁer

Surface Mount Kit

Part No. 4037766

Parts Included:

1. Foam Tape - 4" Long (x6)

2. Foam Tape - 24" Long (x2)

3. Surface Mount

4. Screw A - #10 Wood Screws (x5)

Screw B - #8 Sheet Metal Screws (x5)

6. Plastic Grommet / Drain Hose Bushing

Tools Required:

• Drill / Screwdriver

• Long Bit Extender (optional)

34.1"

6.2"

17.6"

Identify the front side of the

surface mount kit by locating the

semi-circular cutouts along the

inside edge.

Install 4" foam tape to the front

as shown. Do not cover holes for

fastening.

Install 24" foam tape to the back

as shown. Do not cover holes for

fastening.

(x5)

CONTINUED

BACK

24"

FRONT

TOLL-FREE 1-800-558-1711

•

www.Broan-Nutone.com

TS-1222 10/21 Rev A

Summary of content (4 pages)

PAGE 1
In-Wall Dehumidifier Surface Mount Kit Part No. 4037766 6.2" Parts Included: Tools Required: • Drill / Screwdriver • Long Bit Extender (optional) 4 (x5) 3 34.1" 1. Foam Tape - 4" Long (x6) 2. Foam Tape - 24" Long (x2) 3. Surface Mount 4. Screw A - #10 Wood Screws (x5) 5. Screw B - #8 Sheet Metal Screws (x5) 6. Plastic Grommet / Drain Hose Bushing 5 (x5) 6 1 2 17.6 " Step 1.
PAGE 2
Step 2. Attach Surface Mount to Wall Locate studs inside the wall 16" apart. Place the surface mount on the wall and ensure it is level. Locate the four holes on the surface mount and fasten to the wall with the appropriate screws based on the stud type. Screw A can be used for wood studs and Screw B can be used for metal studs. SCREW A or B Step 3. Prepare Surface Mount for In-Wall Dehumidifier Installation Punch the appropriate knock out holes for the drain hose and electrical wiring.
PAGE 3
Step 4. Install In-Wall Dehumidifier to Surface Mount Lift and support the dehumidifier by the plastic drain pan below the evaporator coil and place inside of the surface mount. Two people are recommended for this step. Route the drain hose and electrical wiring through the corresponding knock out holes of the surface mount and dehumidifier to connect. Locate the four slotted holes on the dehumidifier. Use Screw A to fasten the unit to the surface mount through the slotted holes.
PAGE 4
Step 5. Install Diffuser Cover Place the hooks of the front diffuser cover into the slots at the base of the dehumidifier before fastening. SECURE BOTH HOOKING LOCATIONS Locate the four holes on the diffuser cover and fasten to the dehumidifier using either Screw C (Tamper Resistant) or Screw D (Phillips Head) included with the unit. Using the tamper resistant screws requires the ¼" Hex T-15 Torx Security Bit included with the unit. SCREW C OR D TOLL-FREE 1-800-558-1711 • www.Broan-Nutone.