Installation guide

5. CHOOSE THE OPENING(S) (INTERNAL BLOWER(S) HOOD ONLY)
Remove the knockout(s) for the chosen opening(s) (horizontal at the back of the hood or vertical on top). See illustrations below.
VERTICAL DISCHARGE
HORIZONTAL DISCHARGE
NOTE: For ducted installation only.
HR0021
Punch out the appropriate electrical knockout
hole on top (A) or back (B) of the hood.
Install the wire clamp (included in parts bag).
NOTE: For a non-ducted installation, punch
out the back electrical knock-out (B).
HD0250
6. REMOVE FILTERS AND THE GREASE DRIP RAIL
A. Remove tape on filters.
Remove filters from hood and set aside.
NOTE: | It is recommended to start with the
center one.
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
HD0243
7. REMOVE THE ADAPTER (INTERNAL BLOWER HOODS ONLY)
Remove the adapter (1), or adapter/damper, taped inside the hood.