Installation Guide

12
This hood requires 120 V, 50 W max., MR16 with GU10 base or PAR16 with GU10 base, shielded halogen lamps (not included).
(2 required for 30" and 36" hood widths, 3 required for 42" and 48" hood widths.)
1. Install lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb
leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing
the bulb.
14. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
HD0241
Reinstall grease drip rail. The illustration at right shows how to reinsert the grease
drip rail into the range hood.
CAUTION
Remove protective plastic film covering filters before installing them.
HD0242
1
2
It is recommended to install side filters first and finish with center one(s).
1. Insert one end of the filter into the upper channel of the hood.
2. Raise the other end towards the inside of hood and insert in the grease drip rail
of the hood.
13. INSTALL LIGHT BULBS
WARNING
!
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a cool beam, a dichroïc lamp, a lamp not suitable for use in
recessed luminaires or identified for use in enclosed fixtures.
12
HO0090