INSTALLATION INSTRUCTIONS HB0072 E64000 SERIES ! INTENDED FOR DOMESTIC COOKING ONLY ! READ AND SAVE THESE INSTRUCTIONS INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER. HOMEOWNER: USE AND CARE INFORMATION ON PAGES 13 AND 14. Broan-NuTone Canada Inc.; Mississauga, Ontario www.broan.ca 877-896-1119 REGISTER YOUR PRODUCT ON LINE AT: www.broan.ca SV20343 rev.
! WARNING ! TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally.
- E64000 SERIES RANGE HOOD SYSTEM INTERNAL BLOWERS MODEL 441 (10” ROUND WALL CAP) (HIGH MODEL 647 (7” ROUND WALL CAP) MODEL 437 CAPACITY ROOF CAP) MODEL 415 (7” ROUND ADJUSTABLE ELBOW) MODEL 418 (10” ROUND ADJUSTABLE ELBOW) MODEL 407 (7” ROUND 2 FT.
- E64000 SERIES RANGE HOOD SYSTEM IN-LINE AND EXTERIOR BLOWERS MODEL 437 (HIGH CAPACITY ROOF CAP) MODEL HLB9 (800 CFM) OR HLB11 (1100 CFM) IN-LINE BLOWER (INCLUDES TWO 8” X 12” TO 10’’ ROUND TRANSITIONS) MODEL 331H (600 CFM) OR 332H (900 CFM) EXTERIOR BLOWER MODEL 335 (1200 CFM) OR 336 (1500 CFM) EXTERIOR BLOWER MODEL 441 (10” ROUND WALL CAP) MODEL 643 (8” ROUND WALL CAP) MODEL HLB6 (600 CFM) IN-LINE BLOWER (INCLUDES TWO 4½” X 18½” TO 10’’ ROUND TRANSITIONS) MODEL HLB3 (280 CFM) IN-LINE BLOWER (INCLU
1. SELECT BLOWER OPTION The Broan Elite E64000 Series range hood includes many configurations: hood with single or double internal blowers (included with the hood), or hood using external blowers. For hood using external blowers, the Broan Elite E64000 Series must be installed with in-line blower model HLB3, HLB6, HLB9 or HLB11, or exterior blower model 331H, 332H, 335 or 336 only. Other blowers cannot be substituted. (Blowers sold separately). Plan where and how the ductwork will be installed.
2. PREPARE THE INSTALLATION ! WARNING When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves. NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
2. PREPARE THE INSTALLATION (CONT’D) Cut-out the openings for duct (A) and power cable (B), in cabinet or wall, according to the direction of discharge chosen. See figures below. NOTE: For all internal blower hoods, the cut-out opening for house wiring can be made in cabinet bottom OR wall, no matter the discharge chosen (vertical or horizontal).
4. REMOVE FILTERS AND GREASE DRIP RAIL A. Remove tape on filters. Remove filters from hood and set aside. NOTE: It is recommended to start with the center one(s). 1 B. Remove tape on grease drip rail (1). Lift out grease drip rail and set aside. HD0240 A B 5. REMOVE THE ADAPTER (INTERNAL BLOWER HOOD ONLY) SINGLE BLOWER HOOD Remove both screws retaining the adapter/damper (1) from inner top of the hood.
6. CHOOSE THE OPENING(S) (INTERNAL BLOWER HOOD ONLY) Remove the knockout for the chosen opening(s) (horizontal at the back of the hood or vertical on top). See illustrations below. VERTICAL DISCHARGE HORIZONTAL DISCHARGE 1 2 3 1 2 3 HR0021 A B Punch out the appropriate electrical knockout hole on top (A) or back (B) of the hood. Install the wire clamp (included in parts bag). HR0024 7.
7. HORIZONTAL DISCHARGE INSTALLATION (INTERNAL BLOWER(S) ONLY) Slide the blower to disengage its flange from the retaining bracket. HD0270 Flip the blower and engage its flange in the back wall retaining bracket. Using a 5/16” socket and the screws previously removed, secure the blower to the hood. HD0271 RIGHT SIDE MOUNTING SCREW LOCATION LEFT SIDE MOUNTING SCREW LOCATION HD0272 Plug the blower in. NOTE FOR DUAL BLOWER HOODS ONLY: Cut off the plastic tie wrap on left motor cable. HE0085 8.
9. INSTALL THE HOOD (ALL BLOWERS) INTERNAL BLOWER: Run power cable to installation location. Place the hood in its location. Mark the position of the screws (smaller part of the key holes [A]) with a pen. Remove the hood and install the (4) 1/2” double thread screws at marked positions, leaving a 1/8” gap. Remove wiring cover. Insert the cable in the hood through the wire clamp and tighten the wire clamp to secure the cable. Place the hood under the cabinet and slide it into position.
. INSTALL LIGHT BULBS This hood requires 50 W max., 120 V with GU10 base, shielded halogen bulbs (not included). (2 required for 30” and 36” hood widths, 3 required for 42” and 48” hood widths). ! WARNING Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk of personal injury, only install shielded halogen lamps. Also, never install a cool beam, a dichroïc lamp, a lamp not suitable for use in recessed luminaires or identified for use in enclosed fixtures. 1 1.
14. USE AND CARE Baffle Filters The baffle filters should be cleaned frequently. Use a warm detergent solution. Wash more often if your cooking style generates greater grease—like frying foods or wok cooking. Remove baffle filters by pushing them towards the back of hood and rotating filters downward. Baffle filters are dishwasher safe. Allow filters to dry completely before reinstalling them in the hood. Clean all-metal filters in the dishwasher using a non-phosphate detergent.
15. OPERATION (CONT’D) 3 4 2 1 A B HC0003 A) Halogen light knob B) Blower speed control knob HC0035 1) Halogen light knob 2) Blower operation indicator 3) ON/OFF blower switch 4) Blower speed control knob COOKTOP LIGHTING (HALOGEN) A 3-position rotary knob (1) controls the halogen lights (OFF - low intensity - high intensity). BLOWER The blower is operated using two controls. Use the ON/OFF rocker switch (3) to start and stop the blower.
17.
18. SERVICE PARTS Broan Elite E64000 Series Internal blower hoods Broan Elite E64000 Series Exterior or In-Line blower hoods 1 3 13 3 9 10 4 12 2 2 11 9 12 4 5 8 10 13 11 19 6 5 20 8 6 18 7 14 14 15 15 16 16 KEY NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 * * *NOT PART NO.
