Installation Guide

INDICATOR
LIGHT
Remote Control Functions (Fig.1)
Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
Press (Delay) and (Light) buttons together to
Reset Filter Alarm.
English
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERY IN ACCORDANCE WITH
LOCAL REGULATIONS.
FCC ID: QUS-BESMARTNEW
IC: 11613A-BESMARTNEW
• Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
• This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
LINKING PROCEDURE
- The remote must be linked to the range hood in order
to work properly.
- This procedure is also useful if there are two or more
products that can be controlled by means of remote
control. For example, in apartments with adjacent
kitchens, showrooms, fairs, etc.
- If the remote is included with the range hood, this
linking procedure will have already been completed
at the factory.
1 - Determine the hood control from list below.
2 - Press and buttons on the remote
simultaneaously for 5 seconds, until the remote
control Indicator Light turns on. Release and
buttons. Press and release button to confirm
the linking. At this point the remote control Indicator
Light starts flashing to confirm the link is active.
3 - Within 3 seconds press and release the Link
Confirm button on the hood control (see below).
HOOD CONTROLS
Hood Control 1
LINK CONFIRM BUTTON - P1
Note: To complete link, press and hold “P1” for
3 seconds.
Hood Control 2
LINK CONFIRM BUTTON - P5
Note: To complete link, press and hold “P5” for
2 seconds.
Hood Control 4
LINK CONFIRM BUTTON - A
Note: To complete link, press and hold “A” until
hood user interface light intensity indicator 1
and 3 flash 3 times.
Hood Control 3
LINK CONFIRM BUTTON - P4
FIG. 1
ABC D
E
1234 123
SPEED
LIGHTING INTENSITY