Installation Instructions

INSTALLATION AND USE & CARE INSTRUCTIONS
OPERATION, MAINTENANCE & CLEANING
7
OPERATION
ON/OFF Blower Push-Button: When blower is OFF,
push this button to turn ON the blower at the last selected
speed. Push this button again to turn OFF the blower.
NOTE: If there is no speed selected (all blower speed push
buttons up), the blower will not turn ON. In that case,
press on the desired speed level push button to activate
the blower.
Blower Speed Level Push Buttons: When
blower is ON, change the blower speed by pressing the
push button corresponding to the desired speed: one line
for LOW, two lines for MEDIUM and three lines for HIGH
speed.
ON/OFF Light Push Button: When lights are OFF,
push once on this button to turn ON the lights. Push this
button again to turn OFF the lights. The LED modules
in this product are the latest in LED cooktop illumination
technology - specially designed to operate in the elevated
temperatures of cooking. They offer bright lighting and last
up to 25 times as long as a standard bulb - with greater
reliability than typical replacement LED bulbs.
Non-Ducted Recirculation Filter
The Non-Ducted Recirculation filter should be
changed every 3 to 6 months. Replace more often
if your cooking style generates extra grease, such as
frying and wok cooking.
STAINLESS STEEL CLEANING
Do:
• Regularly wash with clean cloth or rag soaked
with warm water and mild soap or liquid dish
detergent.
• Always clean in the direction of original polish
lines.
• Always rinse well with clear water (2 or 3 times)
after cleaning. Wipe dry completely.
• You may also use a specialized household
stainless steel cleaner.
Don’t:
• Use any steel or stainless steel wool or any
other scrapers to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction
residues reach the unit. During construction/
renovation, cover the unit to make sure no dust
sticks to the stainless steel surface.
Avoid when choosing a detergent:
• Any cleaners that contain bleach will attack
stainless steel.
• Any products containing: chloride, fluoride,
iodide, bromide will deteriorate surfaces
rapidly.
• Any combustible products used for cleaning
such as acetone, alcohol, ether, benzol,
etc., are highly explosive and should never be
used close to a range.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat.
This thermostat is a device that will turn on or speed up the
blower if it senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower
up to HIGH speed.
When the temperature level drops to normal, the blower will
return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower
even if the hood is turned OFF. When this occurs, it
is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main
electrical panel.
!
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY
BEFORE CARRYING OUT ANY OPERATIONS ON THE
APPLIANCE.
Grease Filter
The grease filter should be cleaned frequently. Use a warm
dishwashing detergent solution. Grease filter is dishwasher safe.
Clean filter in the dishwasher using a non-phosphate
detergent. Discoloration of the filter may occur if using
phosphate detergents, or as a result of local water conditions
- but this will not affect filter performance. This discoloration
is not covered by the warranty. To minimize or prevent
discoloration, hand wash filter using a mild detergent.