Manual

®
ALLURE TM QS1 SERIES
RANGE HOOD
Page 2
PREPARE HOOD LOCATION PREPARE HOOD LOCATION
53
ROOF CAP
SOFFIT _
CABINET.__ _
t
24" - 30" ABOVE
COOKING SURFACE
31/4'' X 10" or
7" ROUND DUCT
(For vertical
discharge)
HOUSE WIRING
or Back of hood)
3W' X 10" DUCT
(For horizontal discharge)
Determine whether hood will discharge vertically (3W' x 10"
or 7" Round), horizontally (3W' x 10" only) or non-ducted. For
vertical or horizontal discharge, run ductwork between the
hood location and a roof cap or wall cap. For best results, use
a minimum number of transitons and elbows.
Use for of ductwork and
diagrams, below, placement
proper
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.
314" X 10"
HOOD MOUNTING SCREWS (4) VERTICAL DUCTING
WOOD SHIMS
(recessed-bottom
cabinets only)
1315/16 '' (30" hood)
1615/16 '' (36" hood) 1315/16 '' (30" hood)
1915/16 '' (42" hood) "_ _-- 1615/16 '' (36" hood)
{-CABINET FRONT 1915/16" (42" hood)
! !
I
71/2 _D
CABINET BOTTOM
1_-51A-_ *-- 5W:-,
r__ VERTOALDUOT 2
bE
ACCESS HOLE ( _ "
_-lW' [
t t
CENTER
LINE
ELECTRICAL t
ACCESS HOLE
(in cabinet bottom)
WOOD SHIMS
(recessed-bottom
cabinets only)
__L_. A CABINET FRONT
dLJ 1/8" 3_"
/'_ | 33A''1 HOARcIZONTAHLo_IOTI T
(" CABINET -t-I / I I"R
\ BOTTOMI_-- s'4_t.-s'4'_I I
15 .... __11 7W_--*I "
13 /16 (30 hood) ,,
,, 1315/16 (30" hood)._,
]615/16 (36" hood) 615/16" (36" hood)
\ ]t9/°/16" (42" hood) I 101 /_" /Ao,, h_,4_
\ HOOD t ._5.°,.......,
MOUNTING CENTER
SCREWS (4) LINE
31,4"X 10" [
HORIZONTAL DUCTING
7
ELECTRICAL
ACCESS HOLE
(in wall)
HOOD MOUNTING SCREWS (4)
_ 1315/1611(30"hood)
I 1615/16 (36" hood) 1315/16" (30" hood)
-- 1915/16" (42" hood) 1615/16 '' (36" hood)
[ _-CABINET FRONT 1915/16" (42"hood)
I1 1BOTTOM
I_! AccEssHOLE
I |'),':'\ FOR 7" ROUND
IK!_\ ouc_ 5'
WOOD SHIMS _ ELECTRICAL
ACCESS HOLE
(recessed-bottom CENTER (in cabinet bottom)
cabinets only) LINE
7 ROUND
VERTICAL DUCTING i
10Y£'
El Run house wiring between service panel and hood location.
PREPARE THE HOOD
7"ROUND
DUCT PLATE
Remove 7" Round Duct Plate from of hood. Set duct
top
plate aside - with mounting screws.
FIWERS
El Remove Filters in Pull down filter
tape holding place.
on
tabs and lift filters out. Set filters aside.