Installation guide

BROAN
ALLURE® QSE1 SERIES
RANGE HOOD
PREPARE THE HOOD
i
DAMPER/DUCT
CONNECTOR
Remove Damper/Duct Connector from inside the hood.
Set connector aside - with mounting screws and parts
bag.
WIRING
COVER
Remove Wiring Cover from inside the hood. Set cover
and mounting screw aside.
-\ ELECTRICAL
CABLE CLAMP
Remove either top or back wiring knockout and install ap-
proved Electrical Cable Clamp.
Page 3
PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 314”x 10”
Vertical Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 314”x 10”
Horizontal Discharge)
[e] Remove appropriate Duct Knockout(s) from top or back of
hood.
TAPE TOP/BACK
UP TO 1” EDGE
SIDE-TO-SIDE
ADJUSTMENT
PIVOT DAMPER/DUCT
CONNECTOR
(Vertical discharge
position shown)
3%” x 10” Ducted Discharge Only: Attach Damper/Duct
Connector over knockout opening. Make sure damper Pivot
is nearest to Top/Back Edge of hood. Remove Tape from
damper flap.
NOTE | Damper/Duct Connector can be installed up to 1-inch
on either side of hood center to accomodate off-center
ductwork. In extreme off-center installations, one end
of the duct connector may need to be trimmed to clear
the electrical cable clamp.