Installation guide

BROAN
ALLURE® QSE1 SERIES
RANGE HOOD
CONNECT WIRING
WARNING: To reduce the risk of electric shock,
make sure power is switched off at the service
panel. Lock or tag service panel to prevent
power from being switched on accidentally.
GREEN
SCREW
Connect House Wiring (120 VAC) to hood. Connect house
black to hood black wire, house white to hood white wire,
and house ground under Green Ground Screw. Securely
tighten cable clamp onto house wiring.
Replace wiring cover.
Page 4
INSTALL HOOD
(4)
\
MOUNTING
SCREW
(4)
Hang hood from (4) Mounting Screws (from parts bag).
Slide hood towards wall until mounting screws are engaged
in narrow end of (4) Keyholes. Tighten mounting screws
securely.
CAUTION || DO NOT PUSH ON FAN BLADE. Pushing on the
blade may cause it to interfere with other hood parts.
TAPE
Connect ductwork to hood. Use Duct Tape to make joints
secure and air tight.
KEYHOLE
DUCT