Install Instructions

VT10W WALL CONTROL INSTALLATION
Locate the control
On the ground floor of the house.
In the center of the house, within the airflow (hallway, living room,
dining room).
At approximately 60 inches from the floor.
Use template on the back of this page:
The two black marks indicate where to drill both
screw holes for screwing the control on the wall.
The 3 grey areas indicate the wire hole options.
Before drilling any holes, make sure the template is
positionned so that the wall control will be upright.
Connect the wires to the wall control following
the color code (YELLOW wire to “Y”, RED wire to
“R”, GREEN wire to “G” and BLACK wire to “B”.
YELLOW
RED
GREEN
BLACK
22622 rev. 01

Summary of content (2 pages)