installation guide

Cut out this 4½” diameter circle

all the way through the wall.

Cut out this 6¾” diameter square

only through the siding.

Cut out on dotted lines.

wall cap for 4-inch round duct

installation instructions

1. Cut out template below and trace

outline on wall. Avoid placement

where house wiring or plumbing is

located.

3. Connect METAL DUCT CONNECTOR to-

gether. Snap SLOTS in DUCT into TABS on

VENT COVER.

99044140A

2. Cut 4½” DIAMETER HOLE all the

way through the wall. If wall is not

flat: Remove any siding or other

outer wall covering from inside 6¾”

SQUARE - to create a at surface.

SLOTS

TABS

VENT COVER

METAL

DUCT CONNECTOR

4½” DIAMETER HOLE

6¾” SQUARE

5. Insert duct through hole in wall and fasten duct to

metal duct connector. Use duct tape on all connec-

tions to make them secure and air-tight.

DUCT

4. Attach DUCT to fan’s DUCT CON-

NECTOR.

6. Secure vent cover to wall with 4 SCREWS

(included). Caulk around vent cover with

a quality caulking compound.

DUCT

CONNECTOR

CAUTION

For dryer

installations:

Use rigid metal

duct only.

PAGE 1
wall cap for 4-inch round duct installation instructions 4½” diameter hole SLOTS es. tted lin t on do Cut ou VENT COVER ter circle ” diame wall. the t this 4½ Cut ou way through all the re ter squa ” diame ing. sid t this 6¾ Cut ou through the only 6¾” SQUARE 1. Cut out template below and trace outline on wall. Avoid placement where house wiring or plumbing is located. 2. Cut 4½” diameter hole all the way through the wall.
PAGE 2
conducto de pared para conducto redondo de 4 pulg. instrucciones de instalaciÓn agujero del diámetro 4½ pulg. ranuras es. tted lin t on do Cut ou cubierta del respiradero ter circle ” diame wall. the t this 4½ Cut ou way through all the conducto del metal re ter squa ” diame ing. sid t this 6¾ Cut ou through the only cuadrado 6¾ pulg. 1. Corte la plantilla abajo y remonte el contorno en la pared. Evite la colocación donde se localiza el cableado o la plomería de la casa.