Installation guide

ALLURE TM WSl SERIES
NuTone ° °o .ooo
Page 4
PREPARE THE HOOD CONNECT WIRING
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 ¼" x 10"
Vertical & for 7"Round
Discharge)
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7"Round
Discharge)
_ WARNING: To reduce the risk of electric shock,make sure power is switched off at the service
panel. Lock or tag service panel to prevent power
from being switched on accidentally.
HOUSE
WIRING
(120 VAC)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3 ¼" x 10"
Horizontal Discharge)
El Remove Duct from back of
appropriate Knockout(_ top
or
hood.
UPTO 1"
SIDE-TO-SIDE
ADJUSTMENT
TOP/BACK
TAPE EDGE
PIVOT'
DAMPER/DUCT
CONNECTOR
(Verticaldischarge
positionshown)
31_'' x 10" Ducted Discharge Only: Attach Damper/Duct
Connector over knockout opening. Make sure damper Pivot
is nearest to Top/Back Edg#_ of hood. Remove _ from
damper flap.
7" Round Ducted Discharge Only: Re-install 7" Round Duct
Plate removed in Step #1 under "PREPARE THE HOOD"
section. Install a 7" round damper (purchase separately).
Damper flap must open freely in direction of air flow (away
from range hood).
To accomodate off-center ductwork, the Damper/Duct
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to Y2" on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
CARDBOARD
to protect
cooktop)
[_ Connect House to hood. Use of
Wiring (120 VAC)
a
piece
Cardboard to protect the cooktop, if necessary.
GREEN
GROUND
SCREW
El Connect house blackto hood black wire, house white to hood
white wire, and house ground under Green Ground Screw.
Securely tighten cable clamp onto house wiring.
El Replace wiring cover.