Technical data

94 Web Tools Administrator’s Guide
53-1002934-02
Configuring port binding
6
5. Click the General tab.
NOTE
The Port Index attribute on the General tab indicates whether a port was swapped. For ports
that were swapped, the attribute name displays as Port Index value (Swapped), as shown in
Figure 14. The value indicates with which port index the port was swapped.
FIGURE 14 Port swapping index
Configuring port binding
To bind a port or ports, perform the following steps.
1. Select a port in the Switch View to open the Port Admin tab.
2. Select the FC Ports tab.
3. Select View > Advanced.
4. From the table, select the port or ports you want to bind.
5. Select Binding > Bind PID from the Actions list.
NOTE
If a port is already bound, a warning message is displayed that the port ID is already bound.
The bound port is not listed in the Bind PID dialog box.
6. Enter the middle byte to be set in the Start Address field.
7. Select the ports under Selected Ports for which you want to set the middle bytes and click the
right arrow (Figure 15).