Technical data

Web Tools Administrator’s Guide 167
53-1002934-02
Port configuration
12
Defining custom static F-N port mapping
In Fabric OS v7.0.0 and later, the Static F port mapping and Static N port mapping columns have
been added to the Port Admin GUI to display static mapping information.
NOTE
Static mappings and custom WWN-N port mappings are mutually exclusive.
To manually change static F-N port mappings, perform the following steps.
1. Click a port in the Switch View to open the Port Admin tab.
2. Click the FC Ports tab.
3. Select Configure F-N Port Mappings from the Actions list.
4. Select the Static Mappings subtab on the right side of the dialog box.
5. In the Primary Mappings area, select ports and use the Add (right arrow) button to map F_Ports
or U_Ports to N_Ports.
6. Optional: Use the Remove (left arrow) button to delete an F_Port mapping from an N_Port.
7. After you have made the appropriate changes, click Save.
Defining custom WWN-N port mappings
NOTE
Static mappings and custom WWN-N port mappings are mutually exclusive.
To manually change WWN-N port mappings, perform the following steps.
1. Select the Port Admin tab.
2. Click the FC Ports tab.
3. Select Configure WWN-N Port Mappings from the Actions list.
4. In the Primary Mappings area, select a WWN from the left pane and a group or port from the
right pane.
5. Click the Add (right arrow) button to map the WWN to the port or port group.
6. Optional: Expand the port in the right page and select the WWN and then use the Remove (left
arrow) to remove the mapping.
7. Optional: Define a failover in the Secondary Failover Mappings area, by selecting the ports
using the Add (right arrow) and Remove (left arrow) buttons to set up the secondary mappings.
The WWN fails over to the secondary mapping if the primary mapped port is offline. If a
secondary port is not defined, the failover moves to any online ports.
8. Optional: To create a detached WWN-N port mapping, enter the WWN value into the WWN field
and click Add.
The detached WWN port is now available for mapping.
9. After you have made the appropriate changes, click Save.
Any unused WWNs are discarded.