Technical data

200 Web Tools Administrator’s Guide
53-1002934-02
Fabric-Wide Consistency Policy configuration
16
• WWNs—Allows only selected WWNs to log in to the fabric through that F_Port. NPIV-capable
device port WWN’s can also be added to the allowed list of device port WWN’s for the
particular F_Port.
When the ADS policy is enabled first time, all the F_Ports are set to All Access and all the devices
are allowed to log in to fabric. This configuration persists for subsequent logins from all devices.
Existing devices that are already logged into the fabric are not affected.
When the ADS policy is disabled, all the allowed lists are cleared and all the devices are allowed to
log in to the fabric.
To configure ADS policy, perform the following steps.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 33.
2. Click Show Advanced Mode.
3. Select the Security Policies tab to configure the ADS policy in Access Gateway mode.
4. Select the ADS option.
5. Select the Enable ADS Policy option.
The Configure Advanced Device Security Port WWN table displays.
6. Optional: Select an F_Port from the table and click the Edit button.
The ADS Port WWN Configuration dialog box displays. You can configure device port WWN’s
that can be allowed to log in to a particular F_Port by adding them to the Selected WWN list.
7. Select either All Access, or a list of selected WWNs.
8. Optional: You can add the detached port WWN to the selected WWN’s list by adding the WWN
in the detached WWN text field and clicking Add.
9. Optional: For a selected F_Port, if you select the Show device WWN connected to this port
check box of the ADS Port WWN Configuration dialog box, only connected devices are listed in
the Available WWNs list. When you clear the check box, all the connected device port WWNs
and detached WWNs added to the AG are listed in the Available WWNs list.
Fabric-Wide Consistency Policy configuration
Fabric-Wide Consistency Policy (FWCP) configures the Fabric Wide Consistency behavior of
distributable ACL policies. The policy ensures that the switches in the fabric enforce the same
policies. Set a strict or tolerant fabric-wide consistency policy for each ACL policy type (SCC, DCC,
FCS) to automatically distribute that database when a policy change is activated. If a fabric-wide
consistency policy is not set, then the policies are managed on a per switch basis.
To set the fabric-wide consistency policy for an SCC, DCC or FCS policy, perform the following steps.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 33.
2. Select the Security Policies tab.
3. Under Security Policies, click FWCP.
4. Select one of the following consistency behavior for the required policy type (SCC, DCC, FCS).
• Absent