Technical data

Fabric OS Administrator’s Guide 8-3
Publication Number: 53-0000518-09
Controlling Access
8
In the following example, the list is empty:
To add a member to the ACL
1. Connect to the switch and log in as admin.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the select prompt, enter 2 to add a member based on its port/node WWN.
4. Enter the WWN of the host to be added to the ACL.
5. At the prompt, enter 1 to verify the WWN you entered was added to the ACL.
6. After verifying that the WWN was added correctly, enter 0 at the prompt to end the session.
7. At the “Update the FLASH?” prompt, enter y.
8. Press Enter to update the nonvolatile memory and end the session.
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 1
MS Access list is empty.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
done ...
switch:admin>