Technical data

9-8 Fabric OS Administrator’s Guide
Publication Number: 53-0000518-09
Viewing Equipment Status
9
Viewing Equipment Status
You can display status for fans, power supply, and temperature.
To display the status of the fans
1. Connect to the switch and log in as admin.
2. Enter the fanShow command:
The possible status values are:
OK Fan is functioning correctly.
Absent Fan is not present.
Below minimum Fan is present but rotating too slowly or stopped.
Above minimum Fan is rotating too quickly.
Unknown Unknown fan unit installed.
FAULTY Fan has exceeded hardware tolerance.
link fail Link failures (LF1 or LF2 states)
loss sync Loss of synchronization
loss sig Loss of signal
frjt Frames rejected with F_RJT
fbsy Frames busied with F_BSY
Table 9-1 Error Summary Description (Continued)
Error Type Description
N
ote
The number of fans, power supply units, and temperature sensors depends on the switch type. For
detailed specifications on these components, refer to the switch hardware reference manual.
The specific output from the status commands varies depending on the switch type.
switch:admin> fanshow
Fan 1 is OK speed is 7010 RPM
Fan 2 is OK speed is 7180 RPM
Fan 3 is OK speed is 7068 RPM
Fan 4 is OK speed is 7116 RPM
Fan 5 is OK speed is 7155 RPM
Fan 6 is OK speed is 7001 RPM
switch:admin>