Technical data

14-2 Fabric OS Administrator’s Guide
Publication Number: 53-0000518-09
Administering Advanced Performance Monitoring
14
Table 14-1 lists commands associated with Advanced Performance Monitoring. For detailed
information on these commands, refer to the Fabric OS Command Reference Manual.
Table 14-1 Advanced Performance Monitoring Commands
Command Description
perfAddEEMonitor Add an end-to-end monitor to a port.
perfAddIPMonitor Add an IP monitor to a port.
perfAddReadMonitor Add a SCSI Read monitor to a port.
perfAddRwMonitor Add a SCSI Read and Write monitor to a port.
perfAddSCSIMonitor Add a SCSI traffic frame monitor to a port.
perfAddUserMonitor Add a filter-based monitor to a port.
perfAddWriteMonitor Add a SCSI Write monitor to a port.
perfCfgClear Clear the performance monitoring settings from nonvolatile (flash)
memory.
perfCfgRestore Restore performance monitoring settings from nonvolatile (flash)
memory.
perfCfgSave Save the current performance monitoring settings to nonvolatile
(flash) memory.
perfClrAlpaCrc Clear an AL_PA device CRC count by the port and AL_PA.
perfClearEEMonitor Clear end-to-end monitor counters on a port.
perfClearFilterMonitor Clears filter-based monitor counters.
perfDelEEMonitor Delete an end-to-end monitor on port.
perfDelFilterMonitor Delete a filter-based monitor.
perfMonitorClear Clear statistics counters of end-to-end, filter-based, and ISL
monitors on a port.
perfMonitorShow Display end-to-end, filter-based, and ISL monitors on a port.
perfSetPortEEMask Set overall mask for end-to-end (EE) monitors.
perfShowAlpaCrc Display the AL_PA CRC count by port or by AL_PA.
perfShowEEMonitor Show user-defined end-to-end monitors.
perfShowFilterMonitor Show filter-based monitors.
perfShowPortEEMask Display the current end-to-end mask of a port.
N
ote
The command examples in this chapter use the slot/port syntax required by SilkWorm 12000, 24000,
and 48000 directors. For SilkWorm 200E, 3016, 3250, 3850, 3900, 4012, and 4100 switches, use only
the port number where needed in the commands.