Technical data

3-4 Fabric OS Administrator’s Guide
Publication Number: 53-0000518-09
Configuring the Telnet Interface
3
3. In response to the System Services prompt, enter y.
4. In response to the telnetd prompt, enter off.
The telnet interface is disabled. If you entered the command during a standard telnet session, the
session terminates.
Example
To enable telnet
1. Connect to the switch through a means other than telnet (for example, SSH) and log in as admin.
2. Enter the following command:
3. In response to the System Services prompt, enter y.
4. In response to the telnetd prompt, enter on.
The telnet interface is enabled.
switch:admin> configure telnetd
Not all options will be available on an enabled switch.
To disable the switch, use the “switchDisable” command.
Configure...
ssl attributes (yes, y, no, n): [no]
http attributes (yes, y, no, n): [no]
snmp attributes (yes, y, no, n): [no]
rpcd attributes (yes, y, no, n): [no]
cfgload attributes (yes, y, no, n): [no]
[31454]: Read 1 license entries for generation 1.
[31454]: Read 1 license records.
System services (yes, y, no, n): [no] y
rstatd (on, off): [off]
rusersd (on, off): [off]
telnetd (on, off): [on] off
configure telnetd