Technical data

Web Tools Administrator’s Guide 6-5
Publication Number: 53-0000522-09
Configuring SNMP Information
6
Setting SNMP Trap Levels
When you set trap levels for the SilkWorm 12000 director or for a SilkWorm 24000 or 48000
configured with two logical switches, it is on a logical-switch basis. This means that for each logical
switch, you must set trap levels individually.
To set trap levels
1. Launch the Switch Admin module as described on page 4-3.
2. Click the SNMP tab (see Figure 6-2).
Figure 6-2 SNMP Tab
3. Select a trap level for a recipient from the corresponding Trap Level drop-down list in the
SNMPv1 and SNMPv3 sections.
The level you select identifies the minimum event level that will prompt a trap.
4. Click Apply.