Technical data

Web Tools Administrator’s Guide 10-21
Publication Number: 53-0000522-09
Managing Zone Configurations
10
Creating a Configuration Analysis Report
The configuration analysis report lists the following:
SAN components (ports, WWNs, and AL_PAs) that are not included in the configuration.
SAN components (ports, WWNs, and AL_PAs) that are contained in the configuration but not in
the fabric.
To create a configuration analysis report
1. Launch the Zone Admin module as described on page 10-3.
2. Click the Config tab.
3. Select a configuration to be analyzed from the Name drop-down list.
4. Click Analyze Config.
A dialog displays, asking if you want to refresh the fabric before running the analysis.
5. Click Yes or No.
The configuration analysis window displays.
Displaying Initiator/Target Accessibility
The Initiator/Target Accessibility Matrix shows a list of initiators and a list of targets and indicates
which initiator can access which target, as shown in Figure 10-6 on page 10-22.
To display an Initiator/Target Accessibility Matrix
1. Launch the Zone Admin module as described on page 10-3.
2. Click the Config tab.
3. Select a configuration to be analyzed for device accessibility from the Name drop-down list.
4. Click Device Accessibility.
The Initiator/Target Accessibility Matrix for Config- Device Selection dialog displays.
5. Select devices you want displayed in the accessibility matrix; click the radio button to select all
devices in the fabric or to select a subset of the devices.
If you select a subset, you must click the devices from the Select Devices list and click Add to
move them to the Evaluate for Accessibility list.
6. Click OK.
The Initiator/Target Accessibility Matrix displays. You can “mouse over” a target to display the
symbolic name of the device. In addition, you can right-click the device nodes and click View Device
Detail to display detailed information about the selected device.