Technical data

Web Tools Administrator’s Guide 1-9

Publication Number: 53-0000522-09

Launching Web Tools

Web Tools EZ

For a SilkWorm 200E or 3250 switch that has already been set up and is configured with Basic User

mode enabled, Web Tools EZ launches, as shown in Figure 1-3. Chapter 2, “Using Web Tools EZ”

describes how to use this interface.

Web Tools EZ supports only single-switch fabrics. If your switch is connected to another switch, Web

Tools EZ displays a message and exits. If this happens, you must disconnect the switch from all other

switches and then relaunch Web Tools.

Figure 1-3 Web Tools EZ Interface

Web Tools

For the SilkWorm 200E and 3250 configured with Basic User mode disabled, and for all other switch

models, Web Tools launches, as shown in Figure 1-4 on page 1-10. Skip to Chapter 3, “Using

Advanced Web Tools” for instructions for using this interface.