Technical data

4-12 Web Tools Administrator’s Guide
Publication Number: 53-0000522-09
Configuring Ports
4
To configure system services
1. Launch the Switch Admin module as described on page 4-3.
2. Disable the switch as described in “Enabling and Disabling a Switch” on page 4-5.
3. Click the Configure tab.
4. Click the System subtab.
5. Check the boxes next to the system services that you want to enable. Uncheck a box to disable a
service.
Note: Checking the Disable RLS Probing box disables RLS probing. Unchecking this box
enables RLS probing.
6. Click Apply.
7. Enable the switch as described in “Enabling and Disabling a Switch” on page 4-5.
Configuring Ports
Use the Ports tab of the Switch Admin module to perform the basic port configuration procedures
described in this section. Figure 4-4 shows an example of the Ports tab.
Figure 4-4 Ports Tab