Technical data

12 of 12 SilkWorm 4100 QuickStart Guide
Publication Number: 53-0000564-01
a. Orient a cable connector so that the key (the ridge on one side of connector) aligns with the slot in the transceiver.
Then, insert the cable into the transceiver until the latching mechanism clicks. For instructions specific to cable
type, refer to the cable manufacturer’s documentation.
b. Repeat Step a for the remaining transceivers as required.
6. Check the LEDs to verify that all components are functional. For information about LED patterns, refer to the
SilkWorm 4100 Hardware Reference Manual.
7. Verify the correct operation of the SilkWorm 4100 by typing the switchShow command from the workstation.
This command provides information about switch and port status.
8. Verify the correct operation of the SilkWorm 4100 in the fabric by typing the fabricShow command from the
workstation.
This command provides general information about the fabric.
9. Back up the switch configuration to an FTP server by typing the configUpload command and following the prompts.
This command uploads the switch configuration to the server, making it available for downloading to a replacement
switch if necessary.
Brocade recommends backing up the configuration on a regular basis to ensure that a complete configuration is
available for downloading to a replacement switch. For specific instructions about how to back up the configuration,
refer to the Fabric OS Procedures Guide. The switchShow, fabricShow, and configUpload commands are described
in detail in the Fabric OS Command Reference Manual.
Note
The cable connectors are keyed to ensure correct orientation. If a transceiver does not
install easily, ensure that it is correctly oriented.