User Manual

60 Brocade Adapters Administrator’s Guide
53-1001583-01
SFP management
5
SFP management
The Port SFP dialog box enables you to display the properties that are associated with a selected
small form-factor pluggable (SFP) transceiver.
Displaying SFP information using the BCU
Enter the following command to view the SFP information. If the firmware detects a non-Brocade
SFP, the port is disabled.
bcu diag --sfpshow <port_id>
Refer to “diag” on page 137 for details about this command.
Displaying SFP information using HCM
NOTE
Brocade 804 mezzanine cards connect to the embedded switch modules or embedded interconnect
modules on the Blade System chassis by way of an internal backplane and therefore, the SFP
properties do not apply to the Brocade 804 mezzanine card.
1. Select a port in the device tree.
2. Click the SFP tab in the right pane.
The SFP Properties panel, shown in Figure 23, displays.
FIGURE 24 SFP Properties panel
Details about the port technology and extended link are described in “SFP Properties panel” on
page 107.