Technical data

Secondary Image : 7732899 10/21/10 Z.14.22
Boot Rom Version: Z.14.09
Default Boot : Primary
3.2.11 Configure QoS (DSCP and/or CoS) on HP 6120XG Switches
Prerequisites:
•
It is essential that all switches have been configured successfully using 3.2.3 Configure HP 6120XG
switch (netConfig)
ValueVariable
See Application Documentation and step 2<switch_name>
See Application Documentation (if present)<dscp value>
See Application Documentation (if present)<cos value>
See Application Documentation<switch_platform_username>
See Application Documentation<Vlanid>
1. Virtual PM&C: Login to the PM&C Guest
Login to the PM&C Guest.
2. Virtual PM&C: Determine which devices require QoS Policies
Use netConfig to list the devices in its repository and determine which devices should be configured
with QoS.
# netConfig --repo listDevices
Devices:
Device: 6120XG_IOBAY3
Vendor: HP
Model: 6120
Access: Network: 10.240.8.9
Init Protocol Configured
Live Protocol Configured
Device: C3020_IOBAY1
Vendor: Cisco
Model: 3020
Access: Network: 10.240.8.7
Init Protocol Configured
Live Protocol Configured
Device: cClass-switch1A
Vendor: Cisco
Model: 4948E
Access: Network: 10.240.8.3
Access: OOB:
Service: console_service
Console: cClass-sw1A-console
Init Protocol Configured
Live Protocol Configured
Note: Refer to application documentation to determine which switches or pairs of switches to
configure with QoS, making a note of the DEVICE NAME of each 6120XG switch. These will be
referred to as <switch_name> in the following steps
111
909-2209-001 Revision G, February 2014
3 Procedures