Technical data

2. Brocade switch console: Set the SNMP parameters to the default values
swd77:admin> snmpconfig --default snmpv1
*****
This command will reset the agent's SNMPv1 configuration back to factory default
*****
SNMPv1 community and trap recipient configuration:
Community 1: Secret C0de (rw)
No trap recipient configured yet
Community 2: OrigEquipMfr (rw)
No trap recipient configured yet
Community 3: private (rw)
No trap recipient configured yet
Community 4: public (ro)
No trap recipient configured yet
Community 5: common (ro)
No trap recipient configured yet
Commnity 6: FibreChannel (ro)
No trap recipient configured yet
*****
Are you sure? (yes, y, no, n): [no] yes
3. Brocade switch console: Set security level (to disable SNMP sets and gets)
swd77:admin> snmpconfig --set seclevel
See output. A prompt for security level will appear:
Select 1 and press Enter.
Select SNMP GET Security Level
(0 = No security, 1 = Authentication only, 2 =
Authentication and Privacy, 3 = No Access): (0..3) [0] 1
Select 3 and press Enter.
Select SNMP SET Security Level
(0 = No security, 1 = Authentication only, 2 =
Authentication and Privacy, 3 = No Access): (3..3) [3] 3
Verify settings:
swd77:admin> snmpconfig --show seclevel
4. Brocade switch console:
Set SNMP trap recipient IP addresses
swd77:admin> snmpconfig --set snmpv1
SNMPcommunity and traprecipient configuration:
Community (rw): [Secret C0de] <new_password_rw>
Trap Recipient's IPaddress : [0.0.0.0
Community (rw): [OrigEquipMfr] <new_password_rw>
Trap Recipient's IPaddress : [0.0.0.0]
Community (rw): [private] <new_password_rw>
Trap Recipient's IPaddress : [0.0.0.0]
Community (ro): [public] <new_password>
Trap Recipient's IP address : [0.0.0.0] <trap_recipient_ip>
124
909-2209-001 Revision G, February 2014
3 Procedures