Technical data

You will see following:
Navigate to Enclosure Settings and press OK.
Navigate to the OA1 Ipv4 and press OK. Navigate again to the OA1 Ipv4 and press OK.
On the OA1 Network Mode screen choose static and press OK.
On the OA1 IP address screen fill in IP, mask and gateway. Press OK and then press Accept All.
Navigate to "OA2 Ipv4" on the Insight display and repeat the above steps to assign the IP parameters
of OA2.
3.6.2 Configure initial OA settings via configuration wizard
This procedure will configure initial OA settings using a configuration wizard. This procedure should
be used for initial configuration only and should be executed when the Onboard Administrator in OA
Bay 1 (left as viewed from rear) is installed and active.
Prerequisites:
• If the aggregation switches are provided by Tekelec, then the Cisco 4948/4948E switches need to
be configured using 3.1.1 Configure Cisco 4948/4948E/4948E-F aggregation switches (PM&C
installed)(netConfig).
• If the aggregation switches are provided by the customer, the user must ensure that the customer
aggregation switches are configured as per requirements provided in the Application physical Site
survey and related IP/Network Site survey.
•
In addition,3.6.1 Configure Initial OA IP must be completed.
• If there is any doubt as to whether the aggregation switches are provided by Tekelec or the customer,
contact Tekelec Technical Services and ask for assistance.
• Both OAs are installed.
149
909-2209-001 Revision G, February 2014
3 Procedures