Technical data

What is the address used for network device access? <switch1A_mgmtVLAN_ip_address>
Should the live oob adapter be added (y/n)? y
Adding cli protocol for switch1A using oob...
OOB device access already set: console_service
Device named switch1A successfully added.
To check that you entered the information correctly, use the following command:
# netConfig --repo showDevice name=switch1A
and check the output, which will be similar to the one shown below.
# netConfig --repo listDevices
Device: switch1A
Vendor: Cisco
Model: 4948E
FW Ver: 0
Access: Network: 10.240.64.34
Access: OOB:
Service: console_service
Console: switch1A_console
Init Protocol Configured
Live Protocol Configured
#
32. Virtual PM&C: Setup netConfig repository with switch information
Use netConfig to create a repository entry for switch1B. This command will give the user several
prompts. The prompts with <variables> as the answers are site specific that the user MUST modify.
Other prompts that don't have a <variable> as an answer must be entered EXACTLY as they are
shown here.
Note: The model can be 4948, 4948E, or 4948E-F depending on the model of the device. If you do
not know, stop now and contact Customer Care Center.
Note: The switch name must not exceed 20 characters
# netConfig --repo addDevice name=switch1B --reuseCredentials
Device Vendor? Cisco
Device Model? 4948E
Should the init oob adapter be added (y/n)? y
Adding consoleInit protocol for switch1A using oob...
What is the name of the service used for OOB access? console_service
What is the name of the console for OOB access? switch1B_console
What is the device console password? <switch_console_password>
Verify Password: <switch_console_password>
What is the platform access username? <switch_platform_username>
What is the platform user password? <switch_platform_password>
Verify Password: <switch_platform_password>
What is the device privileged mode password? <switch_enable_password>
Verify Password: <switch_enable_password>
Should the live network adapter be added (y/n)? y
Adding cli protocol for switch1A using network...
What is the address used for network device access? <switch1B_mgmtVLAN_ip_address>
Should the live oob adapter be added (y/n)? y
Adding cli protocol for switch1A using oob...
OOB device access already set: console_service
Device named switch1B successfully added.
32
909-2209-001 Revision G, February 2014
3 Procedures