Technical data

Note: The device name must be 20 characters or less
# netConfig --repo addDevice name=C3020_IOBAY1 --reuseCredentials
Device Vendor? Cisco
Device Model? 3020
Should the init network adapter be added (y/n)? y
Adding netBootInit protocol for C3020_IOBAY1 using network...
What is the address used for network device access? <enclosure_switch_IP>
What is the platform access username? <switch_platform_username>
What is the platform user password? <switch_platform_password>
Verify Password: <switch_platform_password>
What is the device privileged mode password? <switch_enable_password>
Verify Password: <switch_enable_password>
Should the init file adapter be added (y/n)? y
Adding netBootInit protocol for C3020_IOBAY1 using file...
What is the name of the service used for TFTP access? tftp_service
Should the live network adapter be added (y/n)? y
Adding cli protocol for C3020_IOBAY1 using network...
Network device access already set: 10.240.8.7
Device named C3020_IOBAY1 successfully added."
To check that you entered the information correctly, use the following command:
# netConfig --repo listDevices
and check the output, which will be similar to the one shown below
Note: Only the switch1B info has been shown in this example. If the previous step and this step
were done correctly, both switch1A and switch1B entries would show up.
# netConfig --repo listDevices
Devices:
Device: C3020_IOBAY1
Vendor: Cisco
Model: 3020
Access: Network: 10.240.8.7
Init Protocol Configured
Live Protocol Configured
[root@pmac5000101 ~]#
Repeat for each 3020, using appropriate values for those 3020s.
13. Virtual PM&C: setup netConfig repository
Note: If there are no 6120s in this deployment, skip to the next step.
Use netConfig to create a repository entry for each 6120XG. This command will give the user several
prompts. The prompts with <variables> as the answers are site specific that the user MUST modify.
Other prompts that don't have a <variable> as an answer must be entered EXACTLY as they are
shown here. If you do not know, stop now and contact Customer Care Center.
# netConfig --repo addDevice name=6120XG_IOBAY1 --reuseCredentials
Device Vendor? HP
Device Model? 6120
Should the live network adapter be added (y/n)? y
Adding cli protocol for 6120XG_IOBAY1 using network...
What is the address used for network device access? <enclosure_switch_IP>
What is the platform access username? <switch_platform_username>
What is the platform user password? <switch_platform_password>
Verify Password: <switch_platform_password>
71
909-2209-001 Revision G, February 2014
3 Procedures