Technical data

For Port Mirroring:

# netConfig --device=<switch_name> addPortMirror session=1

interface=<srcInterface> destInterface=<mirrorPort> direction=both

Note: The interface option allows for more than one source interface. The value can be entered as

a single interface ex: GE1 (1Gb port) or tenGE1 (10Gb port) or it can be entered as a range of interfaces

separated by commas and dashes ex: GE1-5,GE7,tenGE9-10.

Note: The only direction supported by the HP6120XG is 'both.' If the direction option is used on

an HP6120XG, it will be ignored and 'both' is applied.

VLAN Example:

# netConfig --device=C3020_IOBAY1 addPortMirror session=1 vlan=2 destInterface=GE10

direction=both

Port Example:

# netConfig --device=6120XG_IOBAY3 addPortMirror session=1 interface=tenGE1,tenGE3

destInterface=tenGE2

4. Virtual PM&C: Verify the Port Mirroring configuration on the switch

Verify the port monitoring session is configured:

# netConfig listPortMirrors --device=6120XG_IOBAY3

Destination: 2

Source: = (

tenGE1

tenGE3

)

5. Virtual PM&C: Backup the switch configuration

For Cisco:

Perform the 3.1.5 Backup Cisco 4948/4948E/4948E-F Aggregation Switch and/or Cisco 3020 Enclosure

Switch (netConfig) procedure.

For 6120XG:

Perform the 3.2.5 Backup 6120XG Enclosure Switch procedure.

6. Virtual PM&C: Repeat steps 3-5 for each monitor source device.

Repeat steps 3-5 for each monitor source device.

3.2.7 HP 6120XG switchconfig to netConfig Migration

This procedure configures a 6120XG switch to migrate from switchconfig to netConfig.

Needed Materials:

• HP Misc. Firmware DVD,

• HP Solutions Firmware Upgrade Pack Release Notes [3],

• Application specific documentation (documentation that referred to this procedure), and

• Template xml files in an application ISO on an application CD.

909-2209-001 Revision G, February 2014

3 Procedures