Technical data

Fabric OS Encryption Administrator’s Guide (DPM) 37
53-1002720-02
Creating an encryption group
2
4. From the Configure Switch Encryption welcome screen, click Next to begin.
The Designate Switch Membership dialog box displays (Figure 19). The dialog box contains the
following options:
• Create a new encryption group containing just the switch: Creates an encryption group for
the selected switch
• Add this switch to an existing encryption group: Adds the selected switch to an encryption
group that already exists
FIGURE 19 Designate Switch Membership dialog box
5. For this procedure, verify that Create a new encryption group containing just this switch is
selected, then click Next.
NOTE
If you are adding a switch to an encryption, refer to “Adding a switch to an encryption group” on
page 46.
The Create a New Encryption Group dialog box displays (Figure 20).